The K&N filter I'm using is 9inches long [counting the 1" flange]and 7inches wide[the biggest I could fit in there] I then made my own custom sealed heat shield, so that the filter can only suck air in from the original fender hole and in from around the head light. I also made my own MAF adapter. It works great, after over 30 passes at the track, testing all the CAI's I could get my hands on,as well as testing several of my own design, this setup has gotten me the best times.
The K&N filter I'm using is 9inches long [counting the 1" flange]and 7inches wide[the biggest I could fit in there] I then made my own custom sealed heat shield, so that the filter can only suck air in from the original fender hole and in from around the head light. I also made my own MAF adapter. It works great, after over 30 passes at the track, testing all the CAI's I could get my hands on,as well as testing several of my own design, this setup has gotten me the best times.
Thats good to hear, thats the biggest fitler that i think you can fit in there so those times back up it flow characteristics, how did you make you MAF adapter? you got any pics
Thats good to hear, thats the biggest fitler that i think you can fit in there so those times back up it flow characteristics, how did you make you MAF adapter? you got any pics
I just used the stock "plate" that bolts to the MAF. I put a little bit of oil on the inside of the rubber flange on the filter, then heated it up with a hair dryer so it was nice and stretchy and slipped it over top of the protruding opening of the stock plate and then put a hose clamp over it to hold it in place. I then made a mold out of cardboard for the heatsheild, trying different designs till I got it just the way I wanted it, then using the perfected cardboard mold, made one out of black plexi-glass by heating and bending it, to the exact measurements.
Accufab sells an adapter. http://www.accufabracing.com/general.htm#MassAir
I bought mine from the used parts section of one of these boards. I'm also running a 9" K&N. CanadaStang, I'd be interested in seeing your custom heat shield - I've been trying to design one myself, but it's such a tight fit. Please PM me if you have any pics or info to share - thanks!