when i got the stang, there would be drips of oil off the plug, so i got a new magnetic plug, well that helped some, but now there is oil comin from around the oil pan it looks like... where can i get a replacment oil pan for it??? its still factory 302 and a Auto trans..
Might just need new gaskets. If you need an oil pan, you can get them almost anywhere, be it used from a scrap yard or brand new from almost any parts store.
when i got the stang, there would be drips of oil off the plug, so i got a new magnetic plug, well that helped some, but now there is oil comin from around the oil pan it looks like... where can i get a replacment oil pan for it??? its still factory 302 and a Auto trans..
There is an oil level sensor located on the side of the oil pan which also has its own gasket. The sensor is located on the drivers side of the pan. Did you check if it is leaking through there? Mine was. I just replaced the gasket when I had my oil changed and leak was gone. This might help!
There is an oil level sensor located on the side of the oil pan which also has its own gasket. The sensor is located on the drivers side of the pan. Did you check if it is leaking through there? Mine was. I just replaced the gasket when I had my oil changed and leak was gone. This might help!
I had the same problem on 2 stangs and a 302 tbird and all 3 times, it was the same thing: blowby causing internal pressure squeezing the oil out past the seals.
Unscrew the oil filler neck cap (and cover it so crap doesnt fall in..I recommend a dryer sheet and a rubber band) and see if the drip rate does not greatly decrease.
Dont replace the pan, RTV it!! RTV is da ish!! =P
Just drain the oil and paper towel the oil away from the seam and squeeze RTV all around the pan->block seam. Cause dropping a pan is no fun at all but squeezing some rtv is a quick easy fix.
Just drain the oil and paper towel the oil away from the seam and squeeze RTV all around the pan->block seam. Cause dropping a pan is no fun at all but squeezing some rtv is a quick easy fix.