let's see how professional products 75mm/inlet elbow works on 5.4 3v

billfisher

Active Member

Jul 17, 2005

1,296

4

38

huntsville, AL

Apr 25, 2006

#1

• Apr 25, 2006

• #1

let's see if it is worth a damn. a couple of weeks.

 

hotmustang331

Active Member

Apr 29, 2004

2,967

3

48

Bastrop,TX

Apr 25, 2006

#2

• Apr 25, 2006

• #2

Good luck...maybe its good.

 

ADRENLN

Active Member

Apr 16, 2003

2,342

3

49

NJ

Apr 25, 2006

#3

• Apr 25, 2006

• #3

hopefully it works out, let us know

 

propellerhead

New Member

Apr 13, 2004

1,541

0

0

"but what's with the but shots?"

Apr 26, 2006

#4

• Apr 26, 2006

• #4

Did you take a Dremel tool and buzz the insides? Or was it nice and smooth already?

 

billfisher

Active Member

Jul 17, 2005

1,296

4

38

huntsville, AL

Apr 26, 2006

#5

• Apr 26, 2006

• #5

i'm going to polish it inside and widen it where the 5.4 3v intake is wider. i'm also going to modify the rear of the inlet to change the angle to about 70 degrees into the manifold. i'll illustrate it later when it comes in. no 90 degree turn in. i'm going to angle mill the aluminum adapter plate 20 degrees.