I'll try to keep this as short as possible. Last fall, I ordered 1 5/8 BBK LT's, along with a short O/R H pipe. At the same time, I bought a set of gt-40 irons from a guy in chicago, who offered to install all of them for a good price. About a month after this, I blow a header gasket...then the other one...so I let it sit for most of the winter, until I can get some cash in the spring(I used to work seasonally) to fix it. I was able to replace the passenger side header gasket myself, since I could pull the header back about 1 inch and slip the new one in...but the passenger side I had no luck whatsoever; wouldn't go back a 1/2 inch even. I took it to the shop(a pretty well known speed shop in milwaukee, apparently they work on a lot of 5.0's), and they say they had to remove the h pipe to be able to move the LT's around to get at that gasket. He also says those long tubes weren't fitting like they should, that I should probably get new ones...wtf? I just bought them in november. Can you mess up an install of long tubes that badly where they seem to be fine but do what I describe? I don't know where to turn, I can't afford new long tubes with professional installation...I just ordered an american thunder catback which came via fedex today, so that is waiting to be installed...and he also said to install a new catback I'd have to remove the H pipe. What is going on here?? I'm practically desperate, and as a soon-to-be college student, also broke as hell.