Main Girdle question??

[GT_green_GT]

Will a main girdle off a 347 work on a 351w?

 

[Venom351R]

What set up are you doing on the 351 swap?

 

[GT_green_GT]

I just bought a 351w roller motor. Im using the crank and block only. Forged pistons and rods. Hopefully the trick flow top end kit. its got a tubular k member now.

 

[Venom351R]

should strap on some AFR 185's and a Trick flow R inake for the 351W and it will haul ass

 

[GT_green_GT]

185's would be too tiny. i was thinkin the cnc d trick flows.

 

[revhead347]

To answer the question, no I don't think it will.

Kurt

 

[Venom351R]

185's would be too tiny. i was thinkin the cnc d trick flows.

Its just right for a 351W either those or 205's. The trick flow top end kit heads are smaller then AFR 185's to begin with.

 

[S351Saleen77]

Girdle's are different, so is the oil pan and lower intake.

 

[Yobi1Kanobi]

On a 351 block I probably wouldn't even use it

 

[GT_green_GT]

Any two bolt main motor would benefit from a main girdle.

 

[revhead347]

Any two bolt main motor would benefit from a main girdle.

Not really. If you aren't spinning it over 6500rpm, it doesn't really benefit at all. Just more weight and one more thing to work around and make clearance issues.

Kurt