Today I put my exhaust back together. Added the catless BBK X-pipe. Had to reposition the hangers and massage it in to place. I used two inch stainless steel bolts. 3 inchers would have made the whole process quicker.
So the engine, transmission, rear axle, and exhaust are all in place. Tomorrow's project is to replace the heater core. Still have to hook up the speedometer cable and clutch quadrant.
Once I figure out how to reconnect the harness and plugs, I can fire it up.
Doesn't the sensor thats attached to the drivers side 02 sensor plug go in the oil pan sensor? If so, its coming up short. Also need to figure out what to plug since I deleted the smog pump. The block is plugged. Oh well, the fun part is putting it all back together.
So the engine, transmission, rear axle, and exhaust are all in place. Tomorrow's project is to replace the heater core. Still have to hook up the speedometer cable and clutch quadrant.
Once I figure out how to reconnect the harness and plugs, I can fire it up.
Doesn't the sensor thats attached to the drivers side 02 sensor plug go in the oil pan sensor? If so, its coming up short. Also need to figure out what to plug since I deleted the smog pump. The block is plugged. Oh well, the fun part is putting it all back together.