No, they will not work. The housings and electronics are married pairs. The fox III (non Cobra) electronics need a 55 mm housing, just as our F2 electronics need a 70 mm housing.
I run into it every month or so - people buy MAFs for their 94/95 with Foxbody calibrations or C&Ls with Foxbody sensors in 'em. I'll tune it in (I like working with factory electronics) and they always work great.
I run into it every month or so - people buy MAFs for their 94/95 with Foxbody calibrations or C&Ls with Foxbody sensors in 'em. I'll tune it in (I like working with factory electronics) and they always work great.
just asking cause my elecrtonics on my stock mass air went south and my bud has a the working elecrtonics from his fox.i thought i might be able to just swap the electronics over untill my other motor is done.i have 30 lbers and a pro m for that motor.
It would work "ok" for down low but I would honestly just buy or troll up a stock sensor (I bet a lot of guys on here have some). The MAF is the brains behind the operation, you want it as accurate as possible so that you aren't over/under fueling the motor. This is one of those things you want to do right.
I just gave my last two spares away or I would send you one I've got.