Fox MM strut bar

kendawg73 · Oct 25, 2019

My upper intake or distributor are not installed yet.... If I install the MM strut bar can the upper and dist. still be installed after ? (basically can the upper and dizzy be removed/install without removing MM strut bar).

Mustang5L5 · Oct 25, 2019

looks Like it can be done

kendawg73 · Oct 25, 2019

Mustang5L5 said:
looks Like it can be done

yeah, I figured the upper can, I'm more concerned with the distributor... since I won't be putting that in till I can finally start the motor for the first time... looking like after winter :-( so I can keep priming the pump here and there to put oil through motor.

wanted to start bolting stuff back into the engine bay ect... and would like to get the bar on (I already fitted and drilled the holes a few weeks ago) so I can feel like I got some stuff done... lol

Mustang5L5 · Oct 25, 2019

I though I had some better pics but can’t locate them. The bar passes over the rear 1/3 of the dist. With the cap off, you have a few inches where you can pull the dist up and tilt it forward. Might be tight but I think it can work.

Unfortunately I pulled this all apart so I can’t test it for you

Wayne Waldrep · Oct 25, 2019

I have the MM brace and yes the distributor can be removed.

OldManRiver · Oct 25, 2019

On my AC car I needed to remove the compressor line(wasn't charged),if no AC the distributor can be removed/installed with STB in place.

Wayne Waldrep · Oct 25, 2019

My a/c line wasn't in the way....All this info just for reference of course.
Your results may vary and are NOT covered under the fair posting act of 1936.

trebor3170 · Oct 26, 2019

Why worry about it, the first thing I do when I need to do any engine bay work on my 95, is remove the strut tower brace, it's only 8 bolts, that are very easy to get to. You may be able to work around it, but it's a 5 minute no brainer to remove it.

Mustang5L5 said:
looks Like it can be done

I spy, a Craftsman rachet, a Harbor Freight LED light (freebie, maybe, got a few myself), A Dewalt (maybe, looks too bright a yellow, but could just be the pic) 1/4 impact driver.

Oh, btw, your front tires are on the wrong sides, the V's should be facing forward on top.

Mustang5L5 · Oct 26, 2019

Those are my junk winter storage wheels. The tires are 21 years old....so I’m not planning on driving anywhere with them.

And good eye on everything else but you missed the dewalt impact on the floor on the left.

I have soooo many of those freebie HF LEDs

Fox MM strut bar

kendawg73

Well-Known Member

Mustang5L5

That is…until I whipped out my Bissell

kendawg73

Well-Known Member

Mustang5L5

That is…until I whipped out my Bissell

Wayne Waldrep

Before I post a pic, do you have one of yours?

OldManRiver

Active Member

Wayne Waldrep

Before I post a pic, do you have one of yours?

trebor3170

mine usually gets hard with the car on

Mustang5L5

That is…until I whipped out my Bissell

Similar threads

Fox MM strut bar

Well-Known Member

That is…until I whipped out my Bissell

Well-Known Member

That is…until I whipped out my Bissell

Before I post a pic, do you have one of yours?

Active Member

Before I post a pic, do you have one of yours?

mine usually gets hard with the car on

That is…until I whipped out my Bissell

Similar threads

Privacy & Transparency

Privacy & Transparency