im ready to install my whole msd setup in my 95 and im not quite sure where I should put my 6AL box. I was thinking in the car somewhere but dont know where. Any ideas?
I've had 3 MSD's and a Holley Annihilator burn up under the hood, apparently they don't like the heat. Put it on the passenger side footwell inside the car.
I've had 3 MSD's and a Holley Annihilator burn up under the hood, apparently they don't like the heat. Put it on the passenger side footwell inside the car.
under dash passenger side at the below location i fastened wire to a straightened coat hanger and run it thru the factory seal around where the factory wires are exiting this area into the motor bay and in the motor bay i used black tape and wire loom(see picture below)to protect wires from the exhaust heat. and the oarnge stuff in the picture is sealant i used to seal around the wires i ran thru this area to prevent moisture from entering i should have used clear but the only way you can see it is if you actually look under the dash with your head nearly on the floorboard... View attachment 455935
When you remove the pass. kick panel you will see a hole to run your wires through. Just make sure you wrap the wires in elect or duct tape to prevent the wires from rubbing on the metal firewall.