well, I was inspecting everything today before puttin the motor in and realized that I have a cracked bellhousing where the bottom driverside bolts goes into it.
On top of that, where the top bolt on the drivers side threads into, that part is completely snapped off.
So I was wondering if any of you know where to get, or know of a company that sells T 5 bellhousing. I was hoping to just get a stock one, otherwise I assume I will have to change the clutch fork and pivot stud and all that stuff.
I think I will try putting the motor in and gettin the motor mount bolts tight, than install the tranny. Starting to think that would be easier than droppin the motor in and trying to line it up with the tranny, than doin the motor mounts.
any advice is welcome, I need a bellhousing before I can continue.
thanks guys
On top of that, where the top bolt on the drivers side threads into, that part is completely snapped off.
So I was wondering if any of you know where to get, or know of a company that sells T 5 bellhousing. I was hoping to just get a stock one, otherwise I assume I will have to change the clutch fork and pivot stud and all that stuff.
I think I will try putting the motor in and gettin the motor mount bolts tight, than install the tranny. Starting to think that would be easier than droppin the motor in and trying to line it up with the tranny, than doin the motor mounts.
any advice is welcome, I need a bellhousing before I can continue.
thanks guys