• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Need Help Asap!

  • Thread starter Thread starter 1991_5.0_vert
  • Start date Start date Sep 11, 2005
1

1991_5.0_vert

New Member
Sep 5, 2005
22
0
0
Deer Trail, Colorado
Sep 11, 2005
#1
  • Sep 11, 2005
  • #1
Hey guys, I tried to start the stang this morning and I heard an electrical spark and the car wouldn't start so I popped the hood and my ground wire (running from my positive battery cable) had melted to my battery and was smoking, I touched the wire and it was VERY hot. So I put electrical tape around it (with all intentions of replacing the wire afterwards) and it hesitated to start, I pumped the gas pedal once and it finally started. All the sudden my low coolant light came on so I checked my coolant and it was just fine. So I turn off the car and wait about a minute, go out and attempt to start it again and then nothing, all of my lights, my fuel pump and everything were working and the ground wire got hot again, the engine didn't even attempt to turn over. Please help me out, I have school on Monday and I need to know what I need to do to fix this as soon as possible.
 

jrichker

StangNet's favorite TOOL
In Remembrance. Thank you for your contributions
Mar 10, 2000
27,512
2,813
234
Dublin GA
Sep 11, 2005
#2
  • Sep 11, 2005
  • #2
Possible failure items:
1.) Short in power feed wire from starter solenoid by battery to starter. Look for bare spots in the insulation where it may have melted or rubbed and shorted to the chassis or engine.
2.) Bad connections (disconnect & clean)
3.) Corrosion inside battery cables. Look for swelling or bulges in the cable. The cable will look like a snake that swallowed a mouse.
4.) Failed starter. Pull starter and take it to the auto parts store & have them test it.
 
1

1991_5.0_vert

New Member
Sep 5, 2005
22
0
0
Deer Trail, Colorado
Sep 11, 2005
#3
  • Sep 11, 2005
  • #3
[] YAAY it was the ground. The spot that had melted through was right next to a wire connector, where it looked like the previous owner had extended the ground for some reason. So I snipped the ground back to the original wire, reconnected it and it started right up. The low coolant light went off to, she's runnin great now.
 

1991vert

10 Year Member
Feb 27, 2004
1,103
7
69
Ludlow, MA
Sep 11, 2005
#4
  • Sep 11, 2005
  • #4
it's an inline fuse wire, just replace the wire with another one with an inline fuse...
 
You must log in or register to reply here.

Similar threads

Electrical problem plug in the drivers kick panel
  • Mindseye007
  • Aug 16, 2026
  • Fox 5.0 Mustang Tech
Replies
3
Views
236
Fox 5.0 Mustang Tech Aug 16, 2026
Mindseye007
G
Resolved Smoking Wiring Issue After GT40 Head Swap
  • Grapes
  • Aug 15, 2026
  • Fox 5.0 Mustang Tech
Replies
17
Views
580
Fox 5.0 Mustang Tech Aug 22, 2026
Grapes
G
T
Inside is completely dead
  • TunaCar
  • Oct 18, 2026
  • SN95 4.6L Mustang Tech
Replies
11
Views
324
SN95 4.6L Mustang Tech Oct 20, 2026
DadLife0724
P
Fuel New Eldebrock 1406 problems 1985 GT 5.0
  • Paddyman
  • Oct 22, 2026
  • Fox 5.0 Mustang Tech
Replies
4
Views
173
Fox 5.0 Mustang Tech Nov 2, 2026
manicmechanic007
T
Electrical Brown Connector #31
  • ta66
  • Jul 26, 2026
  • Fox 5.0 Mustang Tech
Replies
2
Views
215
Fox 5.0 Mustang Tech Jul 30, 2026
ta66
T
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?