New TKO- 600 issues!! Help!!

str8stang036

New Member

Dec 28, 2002

1,382

0

0

Miami

Dec 6, 2007

#1

• Dec 6, 2007

• #1

I have a brand new TKO- 600 that I installed on my stang. After I finally put it together I went to crank and its locked. The whole drivetrain is locked. I tried turning it at the crank and nothing. I took the tranny out, and tried turning it at the crank and it turns, no lock up. It seems the problems is at the tranny. Anyone else experience this? It is the only thing holding me back from starting it.

 

C

cbarr300

Member

Jun 6, 2006

746

0

17

goose creek, SC

Dec 6, 2007

#2

• Dec 6, 2007

• #2

It may have been dropped on the tailshaft during shipment. This can cause a lock-up.

does you shifter move around freely?

If it doesn't, then take the inspection cover closest to the shifter off. You'll see 3 rails. On the middle rail you'll see something that slides back and forth (IIRC). take a prybar of some sort and put it between the casing of the tranny and that little movable piece and pry it backwards (DON'T use much force). This will pop it outta third and it will be good to go.

If your shifter doesn't move, let me know. I may be able to get you pics.

 

str8stang036

New Member

Dec 28, 2002

1,382

0

0

Miami

Dec 6, 2007

#3

• Dec 6, 2007

• #3

the tranny itself is not locked up. If I put it in gear I can spin the input shaft and the tail also moves. I picked up the tranny at a local tranny shop. I had some internal work done to it, so I doubt that its that it was dropped. Im going to call the shop and let you know.

The shifter moves freely in and out of gears

 

C

cbarr300

Member

Jun 6, 2006

746

0

17

goose creek, SC

Dec 6, 2007

#4

• Dec 6, 2007

• #4

that's good then. Mine did that and it was my problem.

hmmm...maybe something's up with the starter?

You had the car in neutral when you turned the engine over by crank right? can you spin your input shaft when the tranny is in neutral? If so, does it spin the tail shaft?

 

str8stang036

New Member

Dec 28, 2002

1,382

0

0

Miami

Dec 6, 2007

#5

• Dec 6, 2007

• #5

I am thinking that the battery is not fully charged and therefore not letting the starter turn hard enough.

The tranny was in neutral when trying to start it. I can't spin the output because I don't have the driveshaft for it yet. I just tried going through the gears at home and turn the input and in every gear it turned.

 

C

cbarr300

Member

Jun 6, 2006

746

0

17

goose creek, SC

Dec 6, 2007

#6

• Dec 6, 2007

• #6

man, that's a tough one.

If it was the battery I'd think you'd still be able to turn the engine by hand.

maybe someone more knowledgeable than me can chime in on this one

 

str8stang036

New Member

Dec 28, 2002

1,382

0

0

Miami

Dec 6, 2007

#7

• Dec 6, 2007

• #7

I know, its a tough one! LOL