Its just sitting on a Stand now just looks like a coyote motorSure, a few wires, some fire and a couple wrenches, maybe a large hammer too, we'll help you along but we need some pics to get visually stimulated, like car pronz.
Welcome to stangnet.
I have no clue but if I get the help I am looking for i am all for itShould we put this in S197 General/Talk do you think?
Gets my vote.Should we put this in S197 General/Talk do you think?
Taking about the car!!!Its just sitting on a Stand now just looks like a coyote motor
We will try moving this, if you don't get any responses I can at least offer up some bad adviceI have no clue but if I get the help I am looking for i am all for it
Should we put this in S197 General/Talk do you think?
I tried them in just wanting information on how to make it run on a stand I want to make sure it's worth using before I actually install itNot sure that's the right place for it. No disrespect to the S197 folks but the coyote is already preinstalled in their car, so not sure what can be contributed in terms of coyote swap specifics.
We actually don't have a good swap forum. There's the engine swap board in the fox forum, but this is a bit different. I know a little about coyote swaps as it pertains to the fox.
There is a good Facebook group "Coyote Swapped" which has a lot of info on non-Mustang coyote builds.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?