R Rapid New Member Mar 31, 2005 297 1 0 Columbia, SC Jul 26, 2008 #1 Jul 26, 2008 #1 I have a "chirp" from the throw out bearing that stops as I put pressure on the clutch pedal. How much preload should I have on the cable set up? I thought I saw a thread on this before but could not find it...
I have a "chirp" from the throw out bearing that stops as I put pressure on the clutch pedal. How much preload should I have on the cable set up? I thought I saw a thread on this before but could not find it...
jcode68 Active Member Jul 15, 2003 892 1 29 Massachussetts Jul 26, 2008 #2 Jul 26, 2008 #2 Depends on what trans you are running. If you are using a T5, then your TO bearing should have a slight bit of preload so that it is engaged all the time, but just slightly. Not sure on the older 4 speeds, but I believe you don't want any preload.
Depends on what trans you are running. If you are using a T5, then your TO bearing should have a slight bit of preload so that it is engaged all the time, but just slightly. Not sure on the older 4 speeds, but I believe you don't want any preload.
R Rapid New Member Mar 31, 2005 297 1 0 Columbia, SC Jul 26, 2008 #3 Jul 26, 2008 #3 Is a T5 with Mustang Steve cable. I put a turn on the adjustment nut and eliminated the noise. I have not been bale to find any good adjustment info.
Is a T5 with Mustang Steve cable. I put a turn on the adjustment nut and eliminated the noise. I have not been bale to find any good adjustment info.