This is probably a stupid question, but can I use any coil with the Pertronix Ignitor Kit??? because I was thinking about using the Accel Super or Super Stock Coil and I wanted to be sure there wasnt any problems before I spent my money.
I ran an MSD Blaster 2 and Ialso had to deal had that crap. If you are running the resistor wire that comes straight from the ignition or tach, then you will have 12 volts. Some people have to use a ballast resistor if their systems do not work properly. I myself did not need it.
Well I guess what im getting at is it bad to run 12 volts to the Accel super stock coil??? because I know its bad to run a full 12 volts to a stock coil
The instructions with the coil will tell you. I'm runnung an MSD Blaster that requires the resistor wire so my Pertronix has a seperate 12V source directly from the ignition before it splices into the resistor wire.
I'm pretty certain the Pertronix I & II both use coils designed for points ignition. I'm using a their Flamethrower with the I unit and a Mallory Promaster for points with the II unit in my Ranger