Power Door Lock Problem, Help me Figure it out!

Starscream88

New Member

Mar 8, 2003

1,277

1

0

Park Ridge NJ

Jan 9, 2004

#1

• Jan 9, 2004

• #1

Ok I have a problem with the door locks
They dont work!

Well they did, then they decided not too,
None of the switches Do anything except the Passenger side "unlock" button,
This button does work,

The "Lock" dont work on either side, But If Im ever messing around under the dash sometimes all the buttons work fine, Then as soon as I shut the drivers door they all Die again!,
Ok heres the Obvious Fixes and how Ive ruled them out

. Acutators Not working, Ruled out as I know they work
. Switches Not working in the doors, Ruled out as I used a test light and all switches work fine
. Loose connection where the wires meet in the footwell, Ruled out from taking apart and cleaning and using test light.
> No power to the switches, Ruled out because of the test light check.

So I have been through all the obvious, Checked fuses, played with the connections, But I cant fix it for good, And this has only just started, They have worked fine up until now,

So anyone got any hints???

 

HISSIN50

"How long does it take to get help in here?

15 Year Member

Nov 29, 1999

31,179

33

129

Jan 10, 2004

#2

• Jan 10, 2004

• #2

the connectors for them are in the driver kick panel. if you remove the panel, they are behind it, near the top. i would check the connectors out, since you have an apparently intermittant problem (that can fix itself when tinkering under the dash).
thats all i got. good luck.

 

five_o_stang

New Member

Jan 8, 2004

92

0

0

Georgia

Jan 10, 2004

#3

• Jan 10, 2004

• #3

It's probably the actual buttons themselves. Unscrew the little cover and they unplug. You can get replacements off a local junkyard stang. I got mine for free from a yard. I had to replace ALL of mine when I bought my car. Works fine now. Just make sure to get the right color. I have a black interior so it was a bear to find them...but it's an easy fix if it's the problem

 

nito88stang

Founding Member

May 23, 2002

2,012

0

46

Fullerton, California

Jan 10, 2004

#4

• Jan 10, 2004

• #4

Make sure the connector from the harness to the button on the passengers side is connected, this one not being connected causes the whole actuator system not to work. Dont know why but it does and i found out by accident.

 

Starscream88

New Member

Mar 8, 2003

1,277

1

0

Park Ridge NJ

Jan 10, 2004

#5

• Jan 10, 2004

• #5

Well only the Passenger side "unlock" button works, But I have had a test light probe all the other buttons and it does light up every time I push one,
But the locks do nothing,

But yeah when Im tinkering under the dash sometimes Ill find they work, Then I shut the door and there off again,

I have found the connector in the Drivers Footwell, And cleaned it and made sure it was together,
Still nothing,
Where are all the connectors for this harness?

 

trbkrb

Founding Member

Jun 4, 2001

1,976

4

39

Houston, TX

Jan 10, 2004

#6

• Jan 10, 2004

• #6

Jamie,

There is also a connector on the passenger side by the dash, two in each of the doors themselves right below the switchplates (on the earlier ones...Ford did away with these in 91 or 92), and there is a ground wire on the drivers door. Do the windows work fine? if so, you can swap out the switches and totally rule them out, but you have to cut off the locator tab on the window switch, one is round I think and the other is "L" shaped.

Otherwise, it must be the wires in the door, especially if it acts up after you close the door. Mabe one is grounding out.

You sure have had some electrical problems..... they are a pain to fix.

Good luck!

Thomas

 

Starscream88

New Member

Mar 8, 2003

1,277

1

0

Park Ridge NJ

Jan 10, 2004

#7

• Jan 10, 2004

• #7

Yeah the car has been plagued with them after a small electrical fire caused by a fuse that didnt blow,

Ive basically re-wired most of the whole car
Its all coming to a close now but im going to have to play around with this a bit more,

The Windows are fine,
Just the door locks,
I didnt know there was a connector on the passenger side too,
Where is it exactly? In the footwell?
Seems everything to do with the door locks have Pink wires,
Do you think I should just make another ground for them?
Cut the existing one and make a new one?

 

trbkrb

Founding Member

Jun 4, 2001

1,976

4

39

Houston, TX

Jan 10, 2004

#8

• Jan 10, 2004

• #8

Yes I remember the fire.... I sacrificed some sweat getting you that lighter harness, remember?

The pass side connector is in the same basic area as the drivers side one that connects to the door harness. It is kind of behind the glove box in the kick panel area, where the rubber boot from the door comes into the car. If the ground is there in the drivers door and connected well, it should be OK. If the switches are all OK and the actuators are OK, then that leaves the wires and connectors. If the connectors look good, then you may have to pull the wires to check them over real good.

Thomas

 

Starscream88

New Member

Mar 8, 2003

1,277

1

0

Park Ridge NJ

Jan 10, 2004

#9

• Jan 10, 2004

• #9

Thanks Thomas,

thoght that was you!

Its funny you talk to so many people on line you forget who the cool ones are

Im gonna go outside now in the freezing cold and play about with it

Hate the cold

 

trbkrb

Founding Member

Jun 4, 2001

1,976

4

39

Houston, TX

Jan 10, 2004

#10

• Jan 10, 2004

• #10

Well, hey at least you are not stuck at work all weekend when it is a beautiful 57 degrees outside!

Later,

Thomas

 

Starscream88

New Member

Mar 8, 2003

1,277

1

0

Park Ridge NJ

Jan 10, 2004

#11

• Jan 10, 2004

• #11

Didnt get anything done as its too cold,
I ran the car for a few mins to heat it up while I was in it,
When I got out there was 2 ice patches on the ground under my exhaust tips,

Yup, The steam turned to ice!


Toooooooo cold