• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Preparing a 92GT for a 4,000 mile drive

  • Thread starter Thread starter txcanyon
  • Start date Start date Nov 26, 2011

txcanyon

New Member
Aug 29, 2011
15
0
1
Nov 26, 2011
#1
  • Nov 26, 2011
  • #1
I purchased a 92GT with a T-5, while I was home on my mid-deployment leave. It has approx 189,000 miles on it (carfax said it rolled over about 10 years ago from registration records). It has had a few updates from the previous owners. The stock exhaust had been removed, and an off-road xpipe was installed all it has is dumped flowmasters. With the loud exhaust it is hard to tell if it has any engine issues, but it drove magnificently and I took an '10 Camaro SS by surprise one late night in Sept on I635

The transmission exhibited some issues in 3-5th gears. And my brother took it to Dallas Mustang to get a new T-5 installed. They also checked/replaced the rear main and I had a new heavier duty clutch installed.

I bought the car and intend to drive it back to Alaska where I am stationed. I am setting aside money to get the car ready to make the drive without issues I hope.

It has been a while since I've owned an older model car and have to re-introduce myself to it's older tech compared to the newer cars of today.

I plan on doing the normal plugs/wires/distributor cap replacement, along with all the filters/oil. The car is a project to keep me busy when there is snow on the ground for 6months in alaska.

I wont be home till next spring so I have lots of time to research what all I should definitely do, as well as recommendations from fellow Mustang owners here.

Checklist for replacement:
Oil Filter
Air Filter (CAI type)
Fuel filter?
Drain/bleed brake system?
Spark plugs/wires/distributer cap/coil (any recommendations or go with FRPP?)
drain/flush radiator
check timing
remove mufflers from x-pipe and purchase a new GT exhaust

As Needed:
replace front rotors as needed/machine rear drums

This is my first Mustang (my brother had an older early 70 model coupe), and I am extremely excited to be driving, and working on it.
 

betke76

20+ Year Stangneter
Oct 23, 2004
241
9
19
laurel, md.
Nov 26, 2011
#2
  • Nov 26, 2011
  • #2
with that kinda miles ahead of you , test and or replace the battery,alternator, and replace the TFI module. its cheap enough and wont leave you on the side of the road. other than that these cars are as reliable as a new stang
 

wythors

Get off my lawn!!!
Founding Member
May 17, 2000
2,277
35
69
C Addle
Nov 26, 2011
#3
  • Nov 26, 2011
  • #3
I'd add replace and/or repack the front wheel bearings and servicing the differential to that list.
 

cardudeusa

Founding Member
Oct 22, 2002
1,744
5
48
Home of the Florida Gators!
Nov 26, 2011
#4
  • Nov 26, 2011
  • #4
I would also inspect/ replace tires if they need it.
 

betke76

20+ Year Stangneter
Oct 23, 2004
241
9
19
laurel, md.
Nov 26, 2011
#5
  • Nov 26, 2011
  • #5
also check serp belt
 

ID89GT

10 Year Member
May 26, 2008
1,659
18
49
Spokane Valley, WA
Nov 26, 2011
#6
  • Nov 26, 2011
  • #6
Id check for any leaks as well so you can keep an eye on fluid levels on the trip
 

txcanyon

New Member
Aug 29, 2011
15
0
1
Nov 27, 2011
#7
  • Nov 27, 2011
  • #7
Thanks for the obvious things i missed. I'll hold off on the diff servicing as I plan on doing a rear ring swap and 5/lug upgrade winter '12.

The battery is new, I put it on the car after I brought it home. The alternator is a new higher amperage type. I forgot I had a new flywheel installed as well and the starter was checked to ensure it engages fully and no missing teeth.

The previous owner thinks the engine was overhauled before he got it as it looks really clean (not washed clean but lots of new aftermarket parts installed).

I really didnt get a chance to look at it much after I got it home.. had to get to the airport to come back to Afghanistan.
 

S&B

I hate my CT. :(
10 Year Member
Dec 18, 2005
1,634
695
204
Cheesehead
Nov 27, 2011
#8
  • Nov 27, 2011
  • #8
make sure you do the work in TX then maintain the car and check levels as you go. I dont think it should be a big deal if everything is operating. should be fun. And the good thing is if something breaks on the way you know that someone has the parts with in a couple hours when your in the lower 48.
 

dgollem

20+ Year Stangneter
May 5, 2004
211
33
49
Waldorf MD
Nov 27, 2011
#9
  • Nov 27, 2011
  • #9
If they are still on your car, remove the fog lights for the drive. Lots of gravel on the ALCAN and I would bet the fog lights wont survie the trip. Put them back on once you get there. Easy way to save some money. If your paint is good might also want to put a bra on for the trip. The car not you

Depending on what time of the year might also want to get some of those emergency snow chains. Can still snow in the mountain passes in late May early June. Stangs are not the easiest cars to drive in the snow

Its a beautiful drive have made it 3 times myself. Hope to do it on a bike some day too.
 
V

vertvert

Member
Nov 3, 2011
27
0
11
Nov 27, 2011
#10
  • Nov 27, 2011
  • #10
You may consider taking a couple feet of 5/8" heater hose and a couple of clamps. It's a good chance the heater core will give out if it hasn't been replaced yet.
 

txcanyon

New Member
Aug 29, 2011
15
0
1
Nov 27, 2011
#11
  • Nov 27, 2011
  • #11
dgollem said:
If they are still on your car, remove the fog lights for the drive. Lots of gravel on the ALCAN and I would bet the fog lights wont survie the trip. Put them back on once you get there. Easy way to save some money. If your paint is good might also want to put a bra on for the trip. The car not you

Depending on what time of the year might also want to get some of those emergency snow chains. Can still snow in the mountain passes in late May early June. Stangs are not the easiest cars to drive in the snow

Its a beautiful drive have made it 3 times myself. Hope to do it on a bike some day too.
Click to expand...

Made the drive 3 times in less than a year. First time was dead of winter in my truck with a uhaul trailer. 2nd was August with my wife's Mini Cooper on a trailer driven from Fairbanks to Edmonton and back in a week.

back on topic: Good point on the fogs. One has a broken bracket anyways and will be replaced in Alaska when I replace the front bumper. I am driving it back in the summer, I dont think it would make it during the winter being a light rear wheel drive.

Also good point on the heater hose.. I used to drive a '73 F250 with a 390.. heater hose was always stashed behind the seats

I'll have at least 10 days in texas to work on it before we start our road trip (which will take it over 5k miles easily).

Whats the concensous on putting synthetic in it as opposed to older dino oil? My wifes car and my previous imports (Miatas) all loved synth. My truck has been using Synth SUV oil (Mobil 1) since I bought it in Mar'10. With the older engine I would expect some of the older seals to seep a little, but would it be enough to cause concern. My wife and I talked it over, the thought is no more than 500 miles/day, as sitting in a car for that long tends to make your butt sore.

Thanks for the thoughts and ideas.
 
You must log in or register to reply here.

Similar threads

L
1997 V6 Starting issue
  • leanzik04
  • Mar 20, 2026
  • SN95 V6 Mustang Tech
Replies
3
Views
246
SN95 V6 Mustang Tech Mar 20, 2026
Noobz347
I
1994 Cobra - Fuel Pressure Drops Revving at Idle
  • IconicSilverGT500
  • Apr 11, 2026
  • 1994 - 1995 Specific Tech
Replies
16
Views
434
1994 - 1995 Specific Tech Apr 24, 2026
Mcmahst
Drivetrain 83’ Glx convertible C5 Trans help!
  • JacksonJared2113
  • Dec 25, 2025
  • Fox 5.0 Mustang Tech
Replies
2
Views
393
Fox 5.0 Mustang Tech Dec 26, 2025
JacksonJared2113
M
Engine Unexplainable Exhaust Pop and Gurgle
  • Mrnissen122
  • Feb 14, 2026
  • Fox 5.0 Mustang Tech
Replies
12
Views
571
Fox 5.0 Mustang Tech Feb 18, 2026
Noobz347
C
Engine Idle cuts out
  • claypoolxx
  • Mar 7, 2026
  • Fox 5.0 Mustang Tech
  • 2
Replies
25
Views
751
Fox 5.0 Mustang Tech Friday at 5:04 PM
alutwon
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?