I went to NEDT today with NEBOC and ran the dyno. My best numbers were on my third run, where I hit 258 RWHP and 281 RWTQ. My timing was set at 22*BTDC on this run, and my fuel pressure was at 41 PSI, as they has been since the motor was finished. I don't know how the car even ran with that timing. The car also ran really rich, with an air to fuel ratio of like 11.5-12/1. After that run, we tried to bump the timing, and it detonated so bad the dyno operator heard it through his ear muffs. After that, it took three runs to reign in the timing, where it finally ended up at 20*. We turned down the fuel pressure, and my a/f ratio came up to 13/1, which was cool with me. After I got home, my friend gave me a 76mm Pro-M MAF to try. I put it on, took the car for a ride, and it detonated like a mofo. We ended up dropping the timing to approx. 15* BTDC, and now the car is an absolute animal. It pulls harder, faster, and longer than before with no detonation in sight. It kinda sucks that I wasted a whole dyno day on a bad tune setup, because now I know the car has more umph, nad it was capable of more up at NEDT. Needless to say I will be buying the MAF from him, but I'm just trying to guesstimate how much power I'm planting now, because I know my old numbers are junk.