Mystang66 Member Jul 23, 2011 76 16 19 Minneapolis, MN Mar 9, 2021 #1 Mar 9, 2021 #1 While pulling my new, but leaking, main seal, the sleeve I had put on was bent a little. Figured I would go ahead and put another on taking no chances. Anyone have a trick for getting a sleeve off?
While pulling my new, but leaking, main seal, the sleeve I had put on was bent a little. Figured I would go ahead and put another on taking no chances. Anyone have a trick for getting a sleeve off?
S Specracer Active Member Nov 24, 2020 71 31 28 SE MA Mar 9, 2021 #2 Mar 9, 2021 #2 I screwed up my 1st also, I used an inductive coil to heat it ( https://www.theinductor.com/induction-heater-tools/mini-ductor/models/md-venom ), came right off, using a block of wood to tap it off (note engine was out, pan off, and rear rod cap was off).
I screwed up my 1st also, I used an inductive coil to heat it ( https://www.theinductor.com/induction-heater-tools/mini-ductor/models/md-venom ), came right off, using a block of wood to tap it off (note engine was out, pan off, and rear rod cap was off).