Rearend Help

Which ones?

The outer axle bearings and seals should be easy, remove the cover, drain the oil, remove the cross pin retaining bolt, pull the cross pin, push the axles in, remove the c-clips, remove the axles, then pull the seals, and then the outer bearings.

The pinion seal is a bit more involved, you have to remove the pinion nut, pull the yoke, change the seal and reinstall. However, you must retorque the pinion nut in small stages, to get the same preload. Best to get a book for that one.

The carrier and pinion bearings require removal of the carrier. That can also be done, but reassembly of the pinion, crush sleeve, yoke and nut takes some heavy torque, in small stages, to sneek up on the right value. You should have a detailed manual, or a friend with experience for this one.
 
The rear wheel bearings are the ones at the outer ends of the axle tubes. Just follow the steps in part one of my earlier post. It requires removing the rear cover and draining the fluid, pulling the crosspin and c-clips, etc. It can be messy, and can be a time consuming process, probably 4 hours to change both sides. Once you get the cross pin and c-clips out the rest is easy.

Just go carefully when you try to unscrew the cross pin retaining bolt, ie, make sure you use a six point socket, and such. If you round off that bolt head, the fix is a mother......

There have been two types of bearings used at the wheel bearing, one is a tight fit and one is a looser, push in fit. If the original is a press in, it will take an internal bearing puller of some sort to pull it, or some destruction to get it out.

I just did this job on my 89, and the bearings and axles looked fine, so I put new seals in and put it back together.

Also, make sure the fill plug can be removed before you put it all back together. Filling it up, from on the ground, under the car is slow. I use a small pump that fits in the oil bottle.