Removing Alternator Case..How?

Take off the pulley nut, then the three screws around the outside of the case and it should come right apart. Try to match how it matches up as I think it only goes back together one way. Also, re-assembly requires you to remove the 4 hex type headed screws from the "brushes" on the backside of the case. Just pay attention to any spacers and such that may also be on the input shaft... I know there is one there and I can't remember if it goes inside the case or on the outside. Its really not hard, just watch where everything goes and comes from when you take it apart. You need to remove the brushes because they are spring loaded and you can't put the case on as they are in the way and there is no way to hold them back. You'll see what I mean when you get it apart.

yes, I don't see why you couldn't.