• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-

replacing drivers side window switch

  • Thread starter Thread starter ItsStock02
  • Start date Start date Jun 19, 2010
I

ItsStock02

Member
Aug 18, 2008
492
4
19
Westland, MI
Jun 19, 2010
#1
  • Jun 19, 2010
  • #1
I just discovered that my window wont roll up. I can hear the motor clicking when I press the button to roll it down, but nothing when I try to roll it up. The passenger side still works.

Anyways how hard is it to replace the switch? I found a new one on LRS for $20.
 

SjStang00

Member
Feb 20, 2008
157
0
16
Florida
Jun 19, 2010
#2
  • Jun 19, 2010
  • #2
ehhhh sorta kinda. You gotta tear the door apart to get to the window motor. Then you got to take apart some of the components attached to the motor. to replace the motor ( if that is the problem). Be careful, while the window was down my dad sliced some of his fingers attempting to take the motor off the door.
 

SjStang00

Member
Feb 20, 2008
157
0
16
Florida
Jun 19, 2010
#3
  • Jun 19, 2010
  • #3
or are you talking about the actual switch you press to roll down the window? In that case, i have no clue how to change it sorry haha.
 
I

ItsStock02

Member
Aug 18, 2008
492
4
19
Westland, MI
Jun 19, 2010
#4
  • Jun 19, 2010
  • #4
I figured out how to get the switch out. all you have to do is pry it out. I swapped it with the passenger one and it didnt do anything so I gotta buy a new motor.

This came outta no where. lol
 

Maxpowers

Member
Sep 9, 2009
859
2
19
Pittsburgh, Pa
Jun 20, 2010
#5
  • Jun 20, 2010
  • #5
The click you hear when you press down, is the auto-down relay. Mine was doing the same thing.

Be careful taking the plastic apart because there are a few screws holding it in as well as those stupid plastic clips. The panel can be taken off without removing your speakers by the rear view mirror (if equipped).

Do not remove the motor from the assembly while it's in the car. You will hurt yourself. It is spring loaded and sharp. The entire assembly will come out in a matter of minutes. If I remember correctly I had to bend a tab on the left side of the track out of the way, and remove a bolt or two.

You will need two people though. One to hold the window up to the correct height to get the motor components out.
 
I

ItsStock02

Member
Aug 18, 2008
492
4
19
Westland, MI
Jun 20, 2010
#6
  • Jun 20, 2010
  • #6
I got the motor to work again. I took off the door panel and hit the door where the motor is attached while holding the 'up" button and the window came right up.
 

Maxpowers

Member
Sep 9, 2009
859
2
19
Pittsburgh, Pa
Jun 20, 2010
#7
  • Jun 20, 2010
  • #7
ItsStock02 said:
I got the motor to work again. I took off the door panel and hit the door where the motor is attached while holding the 'up" button and the window came right up.
Click to expand...

That's usually a temporary fix. Kinda like hitting a starter to make it work.

You either have a motor going bad (most likely), or a bad connection.
 
I

ItsStock02

Member
Aug 18, 2008
492
4
19
Westland, MI
Jun 20, 2010
#8
  • Jun 20, 2010
  • #8
im sure the motor's going bad. Im ordering a new motor from someone on my local car forum.
 

urban96

bubb rubb says:"woo woooooo"
Founding Member
Sep 24, 2002
3,464
1
69
Syracuse, NY
Jun 20, 2010
#9
  • Jun 20, 2010
  • #9
hold the switch down and while u slam the door shut, window should go right up
 
You must log in or register to reply here.

Similar threads

D
Electrical Weird door wiring issues
  • Dakar09
  • Oct 20, 2026
  • Fox 5.0 Mustang Tech
Replies
4
Views
207
Fox 5.0 Mustang Tech Oct 21, 2026
Dakar09
D
B
Front window issues
  • bruno
  • Nov 7, 2026
  • Fox 5.0 Mustang Tech
Replies
7
Views
208
Fox 5.0 Mustang Tech Tuesday at 10:26 PM
AeroCoupe
D
Mustang not starting
  • Dawry Ramos
  • Sep 12, 2026
  • 2015 - 2023 Specific Tech
Replies
10
Views
415
2015 - 2023 Specific Tech Oct 3, 2026
Dawry Ramos
D
2
new edge coolant leak need advice asap
  • 2vBoogs
  • Tuesday at 8:37 PM
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
2
Views
68
1996 - 2004 SN95 Mustang -General/Talk- Yesterday at 1:51 AM
2vBoogs
2
2
Resolved Electrical mayhem
  • 2000ElectricGreen
  • Mar 13, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
3
Views
496
1996 - 2004 SN95 Mustang -General/Talk- Sep 4, 2026
2000ElectricGreen
2
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?