Ring and Pinion

You NEED to break-in the gears. Some people will say as much as 500 miles. I did a LOT of research before changing my gears and some sources say that the leading cause of early failure with gears is lack of a proper break-in.

I had read somewhere that you can drive the car LIGHTLY 30 minutes (constant driving, including some upshifting and downshifting, up to speeds of 60mph or better) a day for 3 days, allowing full cool down in between (overnight), and after the 3 days, the gears are ready to be thrashed. That being said, I waited 500 miles before I beat on mine.

Check out Yukon Gear's installation instructions. It talks about break-in:

http://www.yukongear.com/Downloads/Technical_Help/Installation_Kit_Instructions.pdf
 
Id break it in alot more than three heat cycles. I would drive 350-500 miles and do it right. Ive done many gear installs and what your trying to do is to allow time for the pinion and ring gear to wear into eachother. A heat cycle isnt a accurate measurement of break in. It is important however to generate heat cycles, and not to drive really far the first time you drive the car after a gear swap. Pinon bearings and carrier bearings have a set prelaod and will generate alot of heat.
 
Yea, it took me forever to do it, too. I was still in school when I did mine, and campus was only like 5 miles away, so I would have had to make 50 trips to and from to get that 500 mile mark. I think after a few short trips, I made a few long ones to make up the mileage, though.
 
Call any big time race shop, think they drive 500 miles with their race car to break in the gears? Ah, no. Make a few laps around the parking lot of the track let it cool, do that a few times then go out and run 8's. Friend of mine just put a 9 in his fox, the builder said make a few runs down the street and let it cool. Do that a few times and put the hammer down. This is in a very serious street car.
 
i would have to agree with everyone if u put some driving time on them then u give them time to develop a wear pattern. gears aren't like a motor a motor with rely on the rings being set by the heating and shrinking of all the components. if u don't let a wear pattern start u could be binding
 
I never did any kind of break in for mine I guess I just got lucky. I had my gears done on friday drove 5 miles home saturday drove 20 miles to the track and made 10 passes. Drove that car as a daily driver for the next 4 years with it seeing the track about every weekend.