Roller Hinge Pins

Hello,

I have been able to remove both of my door hinge after a very long and tiring process. Since I have purchased the right angle adapter for when I tackle the passenger side. I figured while I am in there I might as well replace the door spring as well as the roller wheel so that my door will stop slamming off my leg.

After removing the roller hinge pin and wheel off the driver side I am now unable to insert and replace the new pin. It seems as though the splines are shot on the hinge. Has anybody else had this issue? and if so have you come up with a solution? I have searched through many forums and can't find anything.

Thanks Adam

Thank you for the reply, This is the video I was using to do the project, I tried using vice grips to pull the rolled part out but I wasn't able to. But I was babying it trying not to ruin it either