Solid motor mounts

I run solid engine mounts with a stock transmission crossmember in a SBF/TKO 600 combination and it works fine. My understanding is that with production blocks there is some risk of distorting the block with solid mounts under very high stress loads (when it torques over hard). This could be an old wives tale too I guess. I've never worried about it with the Dart block though, and I only ran Convertible mounts with stock blocks.

-Matthew

I run solid motor mounts on a 5.0 with a aod i was told not to run a solid mount on the trans it could crack the case for the car flexing. only reson i when with solid motor mounts to stop riping out the right side mount. just with solid motor mounts dose kinda shack the car.

Solids up front here. Just a little shakey is all... I used a poly mount for the trans. It's a 5 speed, too.