So, after almost 2 years of abuse, my Spec 3.5 gave up the ghost at the track tonight. This is a 28 spline, sprung hub, 4 puck disk and heavy duty pressure plate, mated to an aluminum flywheel, in front of my Viper T56 trans.. I was on a set of MT ET Street's, and cut a 1.71 60ft coming out of the hole.. as I go to grab second.. it grinds it's @ss off.. Come back around.. and it's making a lot of grinding noise when I try to engage the clutch.. Once in gear, however, it's fine.. so, I think I partially broke some of the material on one of the pucks.. Luckily, I was able to drive the car home..
Anyway.. what do you guys suggest for a replacement? The 4 puck was a bit much for the power that I'm making.. but, I'm fixing to drop in my built short block.. so those numbers will climb to upper 500's at least.. Again.. I need a 28 spline disc that will work with a T56.
Travis
Anyway.. what do you guys suggest for a replacement? The 4 puck was a bit much for the power that I'm making.. but, I'm fixing to drop in my built short block.. so those numbers will climb to upper 500's at least.. Again.. I need a 28 spline disc that will work with a T56.
Travis