Speedometer Needle bouncing....sofa king we tard did

Ive got a 1990 GT, World Class T-5 from a 94 gt with shorted retainer and shaft, running a 4.10 gear out back. I know I dont have the correct speedo gear for me car, running a 19, and need a 23 tooth. Ive been driving the car for about a month now, when I first built it everything was fine and I had a smooth flowing speedo needle. My problem is that now the needle vibrates or bounces up and down within a 10 mph range of what its trying to read. When I put the new speedo cable in :bang: I DID like an idiot lube the speedo cable at the cluster head. Didnt find out your not suppose to do this, because it can hurt it, until a recent post. (1) IS MY SPEEDO BAD BECAUSE OF THIS NOW? (2) WHAT PART WOULD BE BAD? (3) I HAVE A 4 CYL SPEEDO 85 MPH ALSO, WOULD THESE PIECES INTERCHANGE?
 
I am also searching for a good lube to stop the dreaded speedo needle bounce. I tried using some basic grease which helped for about a week, then the needle started bouncing again. It started out with a tiny wiggle, then each day got bigger and bigger, then at many different speeds. I'm trying to find a more permanent lube that might last. I have never seen anyone post about using ATF before. I'm not sure ATF would have the staying power I need. What will cling to the cable, yet not be so thick or sticky that it won't let the cable turn free enough?
This is frustrating.
Ken
 
At this point in time you have nothing to lose. Pull the shaft (inner cable) out, clean it with solvent and let it dry. If the top part of the cable is oily or greasy, flush the housing with solvent. Then lube the bottom 2/3rd's of the cable with WD40. The wiggly needle problem is usually because the shaft part of the cable is binding with the housing. Try re-routing the cable to keep it from having any sharp bends. Also make sure that it does not get too close to the exhaust system.
 
I thought you were only suppose to lube the portion going into the transmission because lube can damage the speedo head, at least thats what I read on another thread. When I first put the car together I didnt have a problem with speedo bounce, now a month later I do. The only thing I can think of is that I damaged the speedo with the grease. :shrug:
 
I thought you were only suppose to lube the portion going into the transmission because lube can damage the speedo head, at least thats what I read on another thread. When I first put the car together I didnt have a problem with speedo bounce, now a month later I do. The only thing I can think of is that I damaged the speedo with the grease. :shrug:

If the lubricant works its way into the speedo head, it usually pegs the needle all the way off scale. Or the speedo reads 100 MPH when you are going really slow. The fact that yours is just jumping around seems more like a cable problem.