Steeda Windshield Banner installation?

70stangcoupe

Founding Member

Nov 12, 2001

2,895

0

0

Winston-Salem, NC

Jun 27, 2004

#1

• Jun 27, 2004

• #1

Got my Steeda Windshield banner today, but no installation instructions. How did you guys install this thing? Does it install straight across (like it was cut) or do you make it contour to the curve in the top of the windshield (If so, how??)? Did you use any soapy water or just stick it on there? Thanks for the info, guys!

 

Screwed2V

New Member

Aug 6, 2003

1,255

1

0

Misery

Jun 27, 2004

#2

• Jun 27, 2004

• #2

Use soapy water and a bank card or something of that nature as a squeegie. Your'e only gonna be able to install the banner however it came. If it's straight, then that must mean you have to install it that way. I'm sure it wouldn't come in a manner that required you to modify it to make it "look right".

 

70stangcoupe

Founding Member

Nov 12, 2001

2,895

0

0

Winston-Salem, NC

Jun 27, 2004

#3

• Jun 27, 2004

• #3

OK, so I peel the back off and make sure the soapy water is all over the windshield, then squeegee all the water out then peel the top part off, leaving the S T E E D A behind?

The vinyl came straight cut, but I figured it would contour to the windshield. Guess not. Thanks for the reply!

 

Screwed2V

New Member

Aug 6, 2003

1,255

1

0

Misery

Jun 27, 2004

#4

• Jun 27, 2004

• #4

Right. Just make sure you get all of the water out from behind the letters or they'll stick to the paper instead of the windshield and take it very slowly. Let the car sit for a couple hours too before you drive it to make sure the letters have adhered to the windshield.