So, I discovered that my 4.56s did in fact get chipped up a bit when the mini spool chunked apart. I just got a great deal on some FRPP 4.10s with 1000 miles already on them. $35. I can't complain, I guess. I have a nice set of Moser 31 spline axles with c-clip eliminators on them too. I was planning on going full spool this time, but I do a bit of street driving with the 'Stang, so I am researching good LSDs. Is the Auburn unit any good? I can grab a new 31 spline Auburn for $200. Otherwise, I can pick up a lightened steel spool for $150. Anyone have any suggestions as to what to put in the middle? I would absolutely love to buy an ected locker, but those are waaaay too much money. I'm pretty much open to anything, besides the mini spool route again.