stock driveshaft diameter

toyman · Feb 14, 2008

Bullitt95 said:
I measured the circumference of both driveshafts (11") and divided the numbers by pi (3.1415926) to get the diameter.

Well I just crawled under mine. The mid shaft circumference is 11 5/16" using a fabric tape. So, 11.3125"/3.1415926 = 3.6008806" diameter. I no longer have my OEM but I vividly recall it being significantly smaller.

toyman · Feb 14, 2008

DDSTANG94 said:
It might be, im sure its hits the muffler, but it might be hitting both, i took the dog bone off and did not put the little plate back on, i dont know how it goes back on...does anyone have a pic of there pinon snunber and the dog bone plate????

The plate mounts above the differential and bolts into the flange on either side. IIRC the raised portion is offset but it should be obvious as to which way it sits when you look at where the snubber would make contact. Can't recall the bolt size but I do recall that you need a shorter length without the dogbone.

DDSTANG94 · Feb 15, 2008

SQUEEZE&STROKE said:
I just pulled all that chit off my car...if you need it let me know, you can have it...just pay shipping.

thanks man but i still got the old stuff

DDSTANG94 · Feb 16, 2008

kk guys update, i went under the car to find out its rubbing the ebrake cables, what do i do to stop this? adjustable snuber?

94-302-vert · Feb 17, 2008

DDSTANG94 said:
kk guys update, i went under the car to find out its rubbing the ebrake cables, what do i do to stop this? adjustable snuber?

I zip screwed mine to the floor boards using some hose brackets...

stock driveshaft diameter

toyman

toyman

DDSTANG94

New Member

DDSTANG94

New Member

94-302-vert

Active Member

Similar threads

stock driveshaft diameter

toyman

toyman

DDSTANG94

New Member

DDSTANG94

New Member

94-302-vert

Active Member

Similar threads

Privacy & Transparency

Privacy & Transparency