stock quarter mile times

[JoeBallz]

does anyone know what the exact stock quarter mile time is for a 2002-2004 Mustang GT coupe in manual?

 

[wms004]

does anyone know what the exact stock quarter mile time is for a 2002-2004 Mustang GT coupe in manual?

well, its just about all the same 99+.. no MAJOR changes were done. Its about 14 -14.2 for a manual. Some freak cars and great drivers on this forum have pulled 13.8 with ideal conditions.

-wade

 

[KaPPaBaLL]

on the average anywhere from 13.9-14.1 w/ 60' of 1.9 stock tires.

there has been 13.6.. pretty psycho huh?

 

[Mr GT 02]

Damn ..Im a sukky driver...I run low 15's consistantly. My best was a 14.6 tho.

 

[StngStr]

My best stock was 13.99@100 with 2.1 60 ft. There is no "exact stock quarter mile time". Everyone is different. Depends on the driver and the car.

 

[Ryan02Stang]

Damn ..Im a sukky driver...I run low 15's consistantly. My best was a 14.6 tho.

Your problems are the MAC cold air and wing. Take those off and I'm willing to bet you would cut .5 of your quarter mile. What is your trap speed, I'm willing to bed its lower than average because of the Cobra R wing

 

[GTvert01]

I turned 14 flat in my vert when it was stock.So, a coupe should be able to get at least that or dip into high 13s with a good driver.

 

[CrazyHorn]

From what I have seen and heard its between 14.2 to about 13.8. It depends on the driver, conditions etc

 

[reeber]

I have a lot of catching up to do. You guys kill my ego with my highly modded '96 running 2.1 60ft times on piece of poop tires pulling 96 mph at 14.50. And I spent a lot of money to get down to these times. I bought the car stock and I was running 15.30's at 91mph.

 

[Ryan02Stang]

I have a lot of catching up to do. You guys kill my ego with my highly modded '96 running 2.1 60ft times on piece of poop tires pulling 96 mph at 14.50. And I spent a lot of money to get down to these times. I bought the car stock and I was running 15.30's at 91mph.

Make PI heads your friend...do the headswap and say hello to 13s

 

[reeber]

Make PI heads your friend...do the headswap and say hello to 13s

I researched PI heads and still have no clue what the cost is. I was thinking about just getting a set of cobra 4 valve heads, but the cheaper way to get me into the 13's are drag radials. They are on the way.

 

[Ryan02Stang]

I researched PI heads and still have no clue what the cost is. I was thinking about just getting a set of cobra 4 valve heads, but the cheaper way to get me into the 13's are drag radials. They are on the way.

People have gotten PI heads as low as $500. With 4V cobra heads there is a LOT of modifications needed to make that work. PI heads should bolt right up!