TB install.......

The Red Monster

New Member

Jan 22, 2006

43

0

0

May 25, 2006

#1

• May 25, 2006

• #1

Hey guys, i was just wonderin if their is any thing special i have to do when installing my new 65MM TB????? like do i have to reset anything..

or do i just pull all the sensors out of my current TB and just switch everything over to the new one????????

lol kinda newbie question but whatever!!! Ha

Thnx

 

95strokerPSU

Member

Jul 29, 2004

986

1

19

Sacramento from Philly

May 25, 2006

#2

• May 25, 2006

• #2

Plug and play, but it might take the computer a little while to get used to it. You might also have to set the IAC in order to get it to idle right and prevent the dreaded hanging rpms. Good luck and if you have any problems after the install, just do a search and you'll find plenty of info.

 

legalize420

Active Member

May 21, 2005

1,541

1

37

South Florida

May 25, 2006

#3

• May 25, 2006

• #3

just a heads up, its going to be a PITA to get the old tps off of there. i stripped the screws tryng to use a philips head and ended up having to get a new one after busting out the rotary tool and putting a nice gash in my old one. you can try and put a grove in the old screw so you can fit a flat head in there. you might be better off just getting a new one, i paid somewhere around $30 for a new one.

 

MysteryMachine

Active Member

Jun 21, 2003

1,835

2

39

Parkesburg, PA

May 25, 2006

#4

• May 25, 2006

• #4

you may have to adjust the one screw not sure if thats considered the IAC one or not. You don't need to adjust the blade stop though I see a lot of people talking about that and I've read somewhere might have been on the paper I got with my new one that your not suppose to mess with it