Hi foks!
I am in the process of repainting the dash of my 66 pony. Most of the knobs and bezels came off without too much of a challenge, other than the ignition switch. I have a couple of books with detailed instructions for removing the puppy, both sets of instructions are slightly different. Here is what I have tried:1- Insert key, turn to ACC and insert paper clip. Turn key clockwise and pull out switch..no luck, bends paper clip.
2-Same as above but remove the paper clip before turning clockwise. Still no luck.
3-Insert key then paper clip then turn to ACC then turn clockwise-no dice either.
Switch will losen and feel like it is going to release when following above steps but only budges about a quarter to half an inch.
Any suggestions?
Thanks!
I am in the process of repainting the dash of my 66 pony. Most of the knobs and bezels came off without too much of a challenge, other than the ignition switch. I have a couple of books with detailed instructions for removing the puppy, both sets of instructions are slightly different. Here is what I have tried:1- Insert key, turn to ACC and insert paper clip. Turn key clockwise and pull out switch..no luck, bends paper clip.
2-Same as above but remove the paper clip before turning clockwise. Still no luck.
3-Insert key then paper clip then turn to ACC then turn clockwise-no dice either.
Switch will losen and feel like it is going to release when following above steps but only budges about a quarter to half an inch.
Any suggestions?
Thanks!