Thermactor Plugging?

Purdytang9 · May 6, 2017

I was look at the back of my heads and it looks like the PO just left the little looks like a tube for the thermators...but I've read in some posts you have to cap them..how would y'all go about doing it?...do I just leave them there?...

jrichker · May 6, 2017

The Ford dealership has plugs for the heads. It is the same plug used on the front of the heads where the accessory mount brackets bolt on.

Dan02gt · May 6, 2017

Unless you can get a tap in there to clean the carbon out of the threads you can forget about putting the plugs in with the heads installed on the car. Trust me I tried. I gave up and cut the tube down to where it sits behind the heads and can't be seen. I also installed a plug in the tube to seal it off.

mikestang63 · May 6, 2017

just cut off the tubes, flip the ends over and reinstall them as plugs

RaggedGT · May 6, 2017

mikestang63 said:
just cut off the tubes, flip the ends over and reinstall them as plugs

This^^^^
Works great

Purdytang9 · May 8, 2017

Well I'll be John brown....how clever...and cheap...why thank you fellas

General karthief · May 8, 2017

Did you save the air pump, hoses and related hardware? They are getting hard to find for restorers, any stock parts removed should be saved for future use, many parts will not be reproduced in the future, I just sold a small bracket from a vintage mustang for stupid money because you can't find them anymore. I bet I've had it for 40 years, was worth the wait.

Purdytang9 · May 17, 2017

Ohh yeah...i have a place in the attic of my garage that has so many mustang parts tou could probably come real close to build ing another mustang...

SlayAllTires · May 19, 2017

http://www.jegs.com/i/JEGS-Performance-Products/555/51495/10002/-1

https://lmr.com/item/LRS-6086AK/1979-95-Mustang-Cylinder-Head-Smog-Plugs-for-50L-58L

Thermactor Plugging?

Purdytang9

jrichker

StangNet's favorite TOOL

Dan02gt

mazing how much gas smell came from that tiny hole

mikestang63

RaggedGT

Been here over a DECADE and still no CT

Purdytang9

General karthief

wonder how much it would cost to ship you a pair

Purdytang9

SlayAllTires

Similar threads

Thermactor Plugging?

StangNet's favorite TOOL

mazing how much gas smell came from that tiny hole

Been here over a DECADE and still no CT

wonder how much it would cost to ship you a pair

Similar threads

Privacy & Transparency

Privacy & Transparency