It runs! I got my MAF in today and wasted no time after work getting everything finished up. All I had left was the AFM Power Pipe, the MAF assembly, putting the S/C back on, and hooking up a few misc. vacuum lines, PCV, and discharge tube. When we first tried it it started, but it dogged out almost immediately. For the first 15 minutes we probably started it about 100 times, it just would not stay running. After enough starts I was finally able to keep it running in the higher RPMs, between 1500 and 3000. It would die still quite a bit even with my foot on the gas, but you could tell it was getting better. After more and more patience and plenty more starts it finally started to learn and you could let it idle at about 1400 before it would die. After about an hour I finally was at a point where I was satisfied, about 1000 RPMs. It took a lot of adjusting on the idle screw, and a lot of running time (probably a half hour), but now it starts right up and idles around 1000. We had a slight oil leak out of the oil sending T, but that was our fault from not tightening it too well. We fixed that and just listened to the exhaust and S/C whine, it is amazing. I started to feel sick to my stomach from how rich it was runnin' and I'm sure my neighbors were ready to call the cops so I shut it down for tonight. I know you guys want pics and probably a video, but my batteries are dead. I will pick more up tomorrow and get you guys plenty of pics and a nice vid. Thanks to you all who said I could do it, you were right, and you saved me $1,300. Rock on :SNSign: