• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 1994 - 1995 Specific Tech

went to the dyno....

  • Thread starter Thread starter 95cobra50
  • Start date Start date May 23, 2004
9

95cobra50

New Member
Feb 19, 2004
167
0
0
May 23, 2004
#1
  • May 23, 2004
  • #1
well I got up there with 10 other people about half stangs(93 saleen with paxton novi 1000, 04 gt, 02 gt, 99 gt,) So i go up there hoping to find out why I get waxed by pretty much every car out on the street even after my full exhaust and 3.73s. So first pull and i put down 180.2 hp and 213.1 tq. I was pissed to say the least but it was popping really bad through every gear and i started to get a lot of questions about what had been done to it(new maf, ignition, lines or pump) but I told them my only mods and they look at my air to fuel ratio and it was off the chart lean(about 20:1) so the chech my fuel pressure and its running 42 lbs so everything there is pre good and i do another run and put down 196.4hp and 228.1tq. Still not happy they and running now 19:1 ratio they unhooked a sensor that connects to the left side of the intake and we run it again and I put down 217.0hp and 253.9tq. I was a lil happier but still not where I want it(now running 17:1 a/f ratio) Well its running a lot better and I'm going back Thursday to run a diagnostic on it and were going to be changing out the fuel pressure regulator and check all the sensors to get my car running more rich. He told me I'm lucky I didn't burn a hole through my pistons. BTW I'm dead even with my buddy in his 1995 TA running consisten 13.8's and we mad 8-10 runs too so that made me quite happy saying i ran a 15.0 before
 

moneypit94

Active Member
May 23, 2003
1,723
2
39
Macomb, IL
May 24, 2004
#2
  • May 24, 2004
  • #2
19:1 and they did a full pull?! I would have been pissed if it was me... They should be watching that when doing the dyno runs... To me that looks lean enough to do some damage...

Looks like your missing some torque too... You get your AFR fixed and it should help that out... Besides that 217 is doing pretty good for the mods you have...

From my understanding torque likes rich conditions..
 

4Jenna

Founding Member
Sep 12, 2001
4,326
6
69
AZ
May 24, 2004
#3
  • May 24, 2004
  • #3
Don't go back there..they should know better. Lucky your motor didn't get tore up.
 

Venom351R

Founding Member
Apr 27, 2002
4,548
41
98
MAINE
May 24, 2004
#4
  • May 24, 2004
  • #4
lean conditions that high are scary. Dont do any hard driving on the car until you get that down in the lower teens for your A/F ratio. If that was a blown car you could say bye bye to your motor, good thing its N/A but even being N/A thats still in the danger zone of being to lean. DONT DRIVE IT HARD!!! you will regret it.
 
You must log in or register to reply here.

Similar threads

I
1994 Cobra - Fuel Pressure Drops Revving at Idle
  • IconicSilverGT500
  • Apr 11, 2026
  • 1994 - 1995 Specific Tech
Replies
16
Views
663
1994 - 1995 Specific Tech Apr 24, 2026
Mcmahst
B
Fuel 1990 installing edelBrock intake
  • Beaker
  • Oct 5, 2026
  • Fox 5.0 Mustang Tech
Replies
8
Views
331
Fox 5.0 Mustang Tech Oct 6, 2026
Noobz347
J
Lack of power on acceleration
  • jameshernandez
  • Aug 30, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
3
Views
189
1996 - 2004 SN95 Mustang -General/Talk- Sep 6, 2026
jameshernandez
J
T
Help with a 95 5L crank no start
  • TheBubbaJoe
  • Nov 4, 2025
  • 1994 - 1995 Specific Tech
Replies
3
Views
566
1994 - 1995 Specific Tech Nov 5, 2025
AeroCoupe
B
Help! Fox with idle issues
  • bbarton
  • Sep 11, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
7
Views
292
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Sep 12, 2026
AeroCoupe
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 1994 - 1995 Specific Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?