right now i have 3.27s, mac off road h, and a mac cat back. im gona be putting my car in a garage over the winter and driving my truck so i figured that while it sits ill have plenty of time to mess around with it. i want to get some power, but without spending to much money, because when i get out of school i want to pull the motor and put a 351w in. i dont want to spend to much money on stuff that i cant swap over to the new motor so i figured ill get a cheep set of heads and intake. if i were to get a upper and lower intake manifold and the heads off of a 5.0 explorer or mountainer and put them on, what kind of gaints do you think i would see. ill also be getting a bigger throttle body, cold air intake, and shorty headers. id probly just get a new gasket and put the intake manifold on as is, but have a machine shop clean the heads up.... no porting or anything. im also getting a clutch quadrent kit and a pro 5.0 short throw and a set of street slicks, not sure what kind yet. right now my best run was a 14.837 @ 95.11mph with a 2.340 60 foot, thats with the car weighing 3458lb with a full tank of gas, subs, and me in it. After the throttle body, cold air, upper and lower intake, heads, shorty headers, short throw, and street slicks, im thinking ill be running around a 14.0 . what do you guys think. also how much of a hp gain do you think ill expect. im gona have my car dynoed befor i start all this. there is a shop with a dyno out here by me at school so im gona have it done befor i put the car away to start working on it.
thanks
thanks