Ok so I am pulling my motor soon and I have a list of thing I am replacing but wanted to know if there is anything else I should do while it out. The things I am replacing are as follows:
Oil pan, oil pan gasket, motor mounts, clutch, resurfaced flywheel, rear main seal, throwout bearing.
Someone told me that it may be a good idea to replace the rod bearings while i am in there. The motor runs great and recently did a H/C/I swap and its runs strong with no issues. So should I take the advice and do the rod bearings too? Is there anything else that should be done while i have everything out? Want to make sure im not forgetting something. Thanks
Oil pan, oil pan gasket, motor mounts, clutch, resurfaced flywheel, rear main seal, throwout bearing.
Someone told me that it may be a good idea to replace the rod bearings while i am in there. The motor runs great and recently did a H/C/I swap and its runs strong with no issues. So should I take the advice and do the rod bearings too? Is there anything else that should be done while i have everything out? Want to make sure im not forgetting something. Thanks