Okay well my drivers side window wont roll up. Theres 12 volts coming from either wire from the switch which is good means the switch is working, but that connector that comes from the one button down module when I check that I only get one current when I push up. Either of the prongs dont respond when I push down.
Let me draw something
ugh that didnt work either lol....hmm
well I get 12 volts from the wires correctly at the switch. After the switch and regulator there is a 2 pin connector that goes to the window motor. When I try to do the same test to that I do not get the right results. Is it a bad one button power down or a bad motor? How can I test the motor? I tried to bypass that one button down thing by taking a wire and connecting it directly to the motor from the switch but it didnt work even though those wires give off 12volts. Wow i'm horrible at writing this. How can I tell if my motor is bad, or my one button down thing? GRR
Let me draw something
Code:
SWITCH
white/black wire UP - 12 volts -------------- Regulator --- 12 volts
Yellow DOWN - 12 volts ------------- Regulator -- Nothingugh that didnt work either lol....hmm
well I get 12 volts from the wires correctly at the switch. After the switch and regulator there is a 2 pin connector that goes to the window motor. When I try to do the same test to that I do not get the right results. Is it a bad one button power down or a bad motor? How can I test the motor? I tried to bypass that one button down thing by taking a wire and connecting it directly to the motor from the switch but it didnt work even though those wires give off 12volts. Wow i'm horrible at writing this. How can I tell if my motor is bad, or my one button down thing? GRR