- Jul 19, 2015
- 32
- 1
- 8
Heres the scene, i got a used 8.8 housing from my local grave yard with no internals. What i have to put in is a locker with 3.73s and a full rebuild. My big issue is what shim do i use to set my pinion depth? No centerline tool. The diff thats in it is a 7.5 so i dont think i should use the shim size in it, and i did luck out and find the shim in the new/used housing, but being from a different car im not sure i should trust its size. Iv heard there is a Master Housing Demension of 4.481. Minus the bearing width i think, but im not 100% on where to take those measurements.
Does anyone have some insight on this so i can get it beat and start makin big moves on it?
Does anyone have some insight on this so i can get it beat and start makin big moves on it?