slow84lx
clean it good before insertion
Out of curiosity, what is the recommended pushrod wall thickness for a mild street engine?
For example, a TFS-1 cammed engine with ported GT40P's?
Stock wall thickness OK? Should thicker walls be considered or required?
What works?
What is "standard"?
What is overkill?
I freely admit that it has been a few years since I researched the TFS website and don't recall. I will do this to the nth degree when I get to that point.
For example, a TFS-1 cammed engine with ported GT40P's?
Stock wall thickness OK? Should thicker walls be considered or required?
What works?
What is "standard"?
What is overkill?
I freely admit that it has been a few years since I researched the TFS website and don't recall. I will do this to the nth degree when I get to that point.