Search results

  1. bchampion

    Brand New Built 302 overheating

    Does it overheat at highway speed (45+mph) or just when you are at idle to or stop/go traffic?
  2. bchampion

    '67-68 Scott Drake Trap Door w/6x9 Speaker Pods

  3. bchampion

    Vacuum Line Locations

    Get some carb cleaner and with the engine running spray it around the base of the carb. You would likely not hear anything if it was just a vacuum hose that was disconnected.
  4. bchampion

    '67-68 Scott Drake Trap Door w/6x9 Speaker Pods

    So I purchased this from Holley, of course no instructions or hardware of any kind came with it. The only thing I see pre-drilled on it is for the latch, and it's obvious that the factory bolts on my current trap door latch will not work here, it will need self tapping screws. As for the...
  5. bchampion

    Engine Engine noise diagnosis (with video)

    My new 408 from Blueprint is making that same sound as yours. Hopefully this is my issues too.
  6. bchampion

    '68 Cooling System Problem

    Issue ended up being the temp senders I was trying. They had the wrong Ohm range for my NVU gauge. Found the right one and no it tracks my mechanical gauge to the T.
  7. bchampion

    '68 Cooling System Problem

    So let's start at the beginning. Back in December I noticed a crack in my intake manifold where my temp sender screws in so time for a new intake manifold. Drained coolant and replaced intake manifold (like 4th time doing this) and while I was at it, swapped in a Cold Case aluminum radiator...
  8. bchampion

    No Brake Fluid to Driver Side Front Caliper

    So I finally decided to clean up my brake line setup as I got tired of how hodge-podge it looked even though it worked just fine. I have manual disc/drum setup. I ditched the factory block and manual proportioning valve and picked up a new distribution block w/proportion valve assembly from NPD...
  9. bchampion

    Ford Part# Needed-GT Hood Extractor Fastener

    Does anyone know the part# for the two clip fasteners studs & nuts that are used to hold the factory GT heat extractors in place? Thanks in advance,
  10. bchampion

    Fog Lights Mounted Behind Grill on a '67-'68

    Has anyone mounted fog lights, factory or aftermarket types, behind their grill for a stealth look?
  11. bchampion

    Am I Reading This Diagram Right?

    It must be right because that's how I wired it and it's working.
  12. bchampion

    Spare Tire Question

    You can find the kit on ebay for $205 also.
  13. bchampion

    Spare Tire Question

    Best explanation yet but I'm still calling bull :poo:. Lawyers probably got involved.
  14. bchampion

    Am I Reading This Diagram Right?

    Yes, mounts on the tranny.
  15. bchampion

    Spare Tire Question

    Thanks. Not getting one with the GT performance package is pretty obvious for the reason you mention above.
  16. bchampion

    Spare Tire Question

    I recently purchased a 2015 Eco boost with the performance package for my daughter, and just like the GT performance, no spare. They can be found easily enough but they all have the disclaimer not available for cars with summer tires. For the life of me, I can't figure out why that would...
  17. bchampion

    Am I Reading This Diagram Right?

    The harness diagram below shows the 4 pin wiring option for 3 wire hall effect sender. The way I read this, the black wire from the sender connects to the Tan/Black from the harness, the white (sender signal) connects to the tan/white from the harness, and the red (power for sender) connects to...
  18. bchampion

    Problem With New Vintage Usa Performance Series Tach

    Tach was bad, sent it back and they fixed it and sent back. In car and now working.
  19. bchampion

    Problem With New Vintage Usa Performance Series Tach

    I think I narrowed it down to a bad tach. I pulled out my old SunPro steering column tach that I use to use, wired it up with some pin connectors to plug into the main harness for power and tach signal, started the car and the tach worked perfectly. All the other gauges in the NVU setup were...
  20. bchampion

    Problem With New Vintage Usa Performance Series Tach

    So I'm having a problem with the Tach that came with the New Vintage USA Performance series mustang DIY kit package. When I turn the ignition to power, the tach needle should jump, but all mine does is ever so slowly creep up to about 200 rpm reading and then stop. When I start the car, the...
Top Bottom
Back
Forums
Menu