Search results

  1. R

    Wrecked Cobra Value?

    I have a 2003 dsg cobra that was totalled yesterday... It was the most heartbreaking day of my life. All stock with 44k was a garage kept close to flawless cobra. The interior is still perfect but the damage was done to driver door, floorpan, driver rear qtr panel, front and rear bumper...
  2. R

    Midpipe dilemna

    You should go with an X instead of the H. An offroad X will actually give good backpressure compared to an offroad H. And they sound better.
  3. R

    Whining issue

    I had this on my 90 lx it whined in all gears except 4th because it is 1/1 straight through. You have a bad bearing on the cluster. When those gears are being used it whines or when its sitting in neutral it whines but when you step on the clutch it stops because nothing inside of the tranny...
  4. R

    Timing Issue

    The valvetrain is good and the Harmonic Balancer is new. I checked the Balancer marks with TDC and it is dead on.
  5. R

    Timing Issue

    Only 2 responses with 74 views??? Come on fellas I need some help here.
  6. R

    Timing Issue

    I have checked the timing gear and the chain because I just recently had to do an oil pump swap so I thought I would check the chain for slack. It all checked good. The distributor gear is good as I have just put a new distributor in. It is definately indexed correctly, TDC and rotor pointing...
  7. R

    Timing Issue

    Those were among the first things I tried. The TPS checks out great and the Maf is really new but I cleaned it anyway. I think it has something to do with the timing or what controls the timing when the spout is plugged in.
  8. R

    Timing Issue

    Ok I have been having a problem with backfiring through the intake. So I have replaced the control module, distributor, plugs, wires, cap, and rotor. I have stabbed my distributor over and over. I set my timing to 13 and put the spout back in and it still hesitates and pops through the...
  9. R

    oil pump shaft broken

    I hope it is. Does anyone have any tricks for getting the oil pan out from under the car without pulling the engine? I know that would be easier but I dont have a cherry picker. I do have a jack and some 2x4s. Any tricks for getting the shaft back into place?
  10. R

    oil pump shaft broken

    I did a cam swap and I think I got some gasket material in the oil pan. My oil pump shaft twisted and broke then I have no oil pressure. What are the chances that my motor is bad? It started in my driveway and I turned it off right away and changed the oil and started it again to see if I had...
  11. R

    Broken Seats

    I have 98 cobra seats in my 90 lx. The only thing I had to do was put a spacer under the right rear bolt on my passenger seat.
  12. R

    oil pump shaft problem,HELP!!!

    Yeah I had the same problem but it was a broken shaft. When I pulled it out with a magnet it looked like a drill bit or a twizzler. So its a new oil pump for me.
  13. R

    what size fuel pump?

    Good question. Since nobody ever responded I will send it out for my own use???
  14. R

    Tips and Tricks for installing Motor Mounts...

    I just put a set of prothanes on mine and all I did was put a block of wood under the bell housing and ever so slightly lifted it. Then just hold your mouth right and wiggle them out.
  15. R

    Where can I get the tool to take out the ignition switch?

    Autozone or Oreilly both have them. They are just a torx bit with holes in the center. I believe it is the T20 tamper proof bit, but its just as easy to buy a little set as I think thats the only way to get them.
  16. R

    Wont start

    It never shuts off when driving...
  17. R

    Wont start

    Anyone?
  18. R

    Code 31 and 66

    Anyone?
  19. R

    Code 31 and 66

    I know that they are mass air voltage too low and evp problem. Whats the fix?
  20. R

    Super hard vibration at 70 when letting off gas

    I am having the same issues as mustanggt950. Exactly!!!
Top Bottom
Back
Forums
Menu