Search results

  1. Fast02

    What are your thoughts on Alum Driveshaft

    60mph and under vibrations are all but gone. Car revs quicker in gear. Its eye candy for your mechanic, tire guy or exhaust guy.
  2. Fast02

    Question about Steeda Underdrive pullies

    +3 with the stock washer.
  3. Fast02

    chin spoiler instalition tips...

    Make sure the spoiler is flush with the bottom of the bumper...dont try to pull it in so its flush with the front fenders or it will look gay, if you set it in place correctly you will have a half inch space between the front of fender and the beginning of the spoiler...at least I did.
  4. Fast02

    Detonation with K&N and XCal 2...

    I have det too and run a K&N. You can take out some timing and richen up the mixture. I backed out 1degree but havent flashed the car yet. I'll let you know if this took care of the issue. I kind of think its my fault because I told the tuner I had a K&N CAI when I should have said K&N drop in...
  5. Fast02

    Synthetic advantages.

    i switched to synthetic in my old car it had 149,000miles on it. I spun a main rod bearing within a week. Dunno if this was due to switching to synthetic or not but I wouldnt do it again on a high mileage car.
  6. Fast02

    Steeda pulley install.

    lol...i feel stupid for posting it now.:p
  7. Fast02

    thinking of switching to mgw short shifter...

    An email from George...great customer service to boot!!! Start from the bottom and read up.:) the springs are a wear item but they should last at least 30-50k miles. they will need replaced maybe every 3-4 years. if you want you can send the shifter back and i can check it over and put...
  8. Fast02

    Steam

    I have heard that for every tank of gas (20gal) a gallon of water exits the exhaust.
  9. Fast02

    Steeda pulley install.

    Ok I picked up a set of Steeda pulleys from a guy here on Stangnet, I forgot what his alias is. He sent them right out to me NIB with instructions and they were the late 01-up set like he said, I was a little nervous at first due to the instructions reading 1996-2000 model. I bought them for...
  10. Fast02

    Is this shop toying with me??

    Dude you're getting a Kenne Bell.
  11. Fast02

    High speed vibration from the rear end.

    When did it start? Was it after the gear install? After the tranny was out for something? Just developed? After swapping rims? You I'm sure already turned the DS 180 deg right? Perhaps also try another known good driveshaft? I think it was always there. The gears were installed...
  12. Fast02

    High speed vibration from the rear end.

    Ok, just had the pinion bearing,crush washer, pinion seal, carrier bearings, axle bearings replaced for the sum of $448. Thats not a bad deal. Problem is the car starts to humm and a vibration starts at 90mph and gets very bad as speed is increased. 80mph the car is fine with no noticable...
  13. Fast02

    Pinion seal leak

    I got my car back today. They replaced the axle bearings, carrier bearings, pinion bearing and crush washer and pinion seal along with retorquing the pinion bearing. The car is much much better now with no slop in the rear end. But at 90+mph im getting a humm from the rear end....I dunno what it...
  14. Fast02

    Tokico Illumina 5-way people come on in!

    does the car still bang or jar when you hit pot holes are does it just suck them up?
  15. Fast02

    how can i advance my timing with Xcal2???? plzz help

    First pick is what I can modify. Timing is +2 -6. I plugged my SCT2 into my OBD2 port and then plugged the usb cable into my laptop and went for a ride while recording many things...too many. lol! I really like it...if you have a 5speed you can setup a launch rev limiter meaning when...
  16. Fast02

    Pinion seal leak

    Dropped my car off this morning at 8am...I called them at 10am and they said they had it apart and was working on it. I called at 3:30pm and they said he just installed the axles back into the tubes with new bearings and replaced the carrier bearings and the pinion bearing. He said they would...
  17. Fast02

    how can i advance my timing with Xcal2???? plzz help

    You may get a better response if you Copy and paste this question at this website. http://www.sctflash.com/forum/
  18. Fast02

    Tokico Illumina 5-way people come on in!

    Does it bang when you hit bumps on 5? or is it tolerable.
  19. Fast02

    Tokico Illumina 5-way people come on in!

    is 5 stiff or soft.
  20. Fast02

    Tokico Illumina 5-way people come on in!

    I'm picking up a set of these in the morning. Right now I have the stock shocks/ struts with Eibach sportlines..man the ride is crazy harsh right now. What settings do you guys run? How much better will the ride be?
Top Bottom
Back
Forums
Menu