Search results

  1. tnardo

    performer rpm install...what goes here??? and which throttle cable

    i cant seem to figure out what goes in these holes look at pic to see where im talking about #1 its a threaded hole. it does not open up into the intake #2 threaded hole. it opens up into the intake...maybe for a vacum fitting??? #3 does the sender for my mechanical temp gauge go here #4...
  2. tnardo

    black and grey connectors on driver side harness

    look what i found Based on 1988 MUSTANG wiring schematics: When you look at the primary harness that goes from the engine to the computer, you should have 3 connectors that tie back into the main wiring harness. One connector is next to the computer and the other two are at the drivers...
  3. tnardo

    black and grey connectors on driver side harness

    Im in the process of doing a 4cyl - 5.0 carb swap. I know it's not really necessary to know what all the wires mean but i would really like to know. i broke some wires when i was relocating the harness. what i need is a pinout for the black and grey connectors....what is each wire for...
  4. tnardo

    one'mo'gain....chassis grounds, engine grounds, battery grounds

    im just finishing up my 4cyl to carbed 5.0 swap. and i need to know what grounds i need to hookup. where does the neg battery cable hookup... there is a round connector on the neg. cable.. i believe it went to the eec harness do i need to do anything with that.... i need a ground strap...
  5. tnardo

    Duraspark help!..everywhere is different .. i need an expert

    http://groups.msn.com/BlackStang/fabpanel.msnw?action=ShowPhoto&PhotoID=651 heres my final copy I'm aloty smarter than i sound tonight been bustin A all week on this car just put in 4 hours of wiring....and thought i might have screwed up
  6. tnardo

    Duraspark help!..everywhere is different .. i need an expert

    lol i couldn't find a text feature ...hahaha
  7. tnardo

    Duraspark help!..everywhere is different .. i need an expert

    thanx 4 the help i got everything wired correct i just need to run a hot in run to the coil and the i terminal to the coil
  8. tnardo

    Duraspark help!..everywhere is different .. i need an expert

    manual trans
  9. tnardo

    Duraspark help!..everywhere is different .. i need an expert

    too broke for an msd right now i like the diagram it s just that the wires switching from red to white and white to red are screwing me up....your red and white are just the wires comming directly out of the module...correct?
  10. tnardo

    Duraspark help!..everywhere is different .. i need an expert

    could i run a power wire to the coil from a toggle switch
  11. tnardo

    Duraspark help!..everywhere is different .. i need an expert

    maybe i can answer my own question tell me if im right one of the two red wires goes to the i terminal on the starter relay the other red goes to the netural saftey swith white wire goes to the positive side of the coil now how do i hookup to the nuteral safty, do i have to alsowhere...
  12. tnardo

    Duraspark help!..everywhere is different .. i need an expert

    im wiring up my duraspark...it's out of an 85 gt along with the distributor. everywhere i look to figure out where wires go i seem to get a different answer.. so let me tell you what i see and what ive done so far I know what to do with the 4 wires that come out 3 goto the dist and the green...
  13. tnardo

    4cyl to carbed 5.0...vapor line on gas tank????

    i cut the line right in front of the pass rear tire..is there something i could do with it other than just leave it open
  14. tnardo

    no ps no ac no smog what belt

    all im gunna run on my car is the alt and water pump what size belt do i need and how do i route it
  15. tnardo

    4cyl to carbed 5.0...vapor line on gas tank????

    emissions...bah humbug.... good deal
  16. tnardo

    Ohhh, **** look at my avatar!!

    hey....me too...yippie skippy maybe one of these days ill get a custom title
  17. tnardo

    removing power steering pump.....

    my buddy did it and im about to... im just finishing my 4cy to 5.0 carbed swap it just like manual steering you'll get used to it i believe he just took the lines and pump off
  18. tnardo

    4cyl to carbed 5.0...vapor line on gas tank????

    i ran new fuel lines all the way with a custom pick up tube i still have a line that runs down the pass side.. i'm guessing it went to the evap canister what do i do with this line can i just leave it hangiong open __________________
  19. tnardo

    tightening rear control arms bolts after 8.8 install???

    4cy to carbed 5.0....vapor line on gas tank??? i ran new fuel lines all the way with a custom pick up tube i still have a line that runs down the pass side.. i'm guessing it went to the evap canister what do i do with this line can i just leave it hangiong open
  20. tnardo

    tightening rear control arms bolts after 8.8 install???

    i installed an 8.8 in my 89 notch. how do i have the car sitting when i tighten the rear control arm bolts.....axle on jackstands?....car on jackstands, axle hanging....or car on jackstand axle partially elevated with jack..???
Top Bottom
Back
Forums
Menu