Search results

  1. C

    Power Steering Rack Return Port Threads

    I either forgot to remove fitting or lost it does anyone know what size the threads are/what size Fitting needs to be used here? I have a reman quick ratio rack I contacted te the rebuider but they were no help.
  2. C

    Engine doesnt turn off

    I have an 88 GT and the other day I parked the car turned off the key switch radio and other accessories turned off but not the engine had to pull the fuel pump relay to get it to shut off. The ECM also stays powered up also till you remove the ground So I figured key switch good ignition...
  3. C

    Help? installing Cobra ECM on 88 SD car

    Would installing a cobra ECM be just the same as doing any other mass air conversion or are there other pin outs or other things:shrug: that would need to be done?
  4. C

    ECM question

    I purchased a new used ECM to do a mass air upgrade but I would like to try to start my new motor and I think my old ECM is no good it was a speed density ECM can I just plug in the new one without changing the wiring harness or will that damage the ECM?
  5. C

    Little help cant keep new engine running

    Ok so I put a 306 short block in my 88 GT with the following mods an E303 cam, and FMS hydraulic roller lifters, explorer intake, 24 lbs injectors, new heads 1.94 intake 1.60 exhaust, stud mounted 1.6 roller rockers i set the valves on the base circle of the cam obviously i have yet to adjust...
  6. C

    Starts hard hard and wont stay runing

    Ok so I have a new 306 short block with an Explorer intake, an E303 cam, 24 lbs injectors, I have removed the smog pump, added an EGR eliminator and block off plate, the car is till stock speed density. It will only stay runinng if I keep my foot on the gas lightly let go and it dies instantly I...
  7. C

    Oil pump pressure problem

    I am thinking that my oil pump in my new engine is not making any pressure about how long should I have to run the pump via the drill priming rod? I am not getting anything comeing out of the heads and nothing in the oil filter either I ran it for a few minutes and no oil anywhere other than in...
  8. C

    Phenolic fitment??

    What is the thickest phenolic you can use with a stock hood?
  9. C

    stud mount rocker help?

    Ok so I am putting my motor together with stud mount rockers do you have set the preload on stud mounted rockers by following the firing oreder or can you just go through and set them?
  10. C

    Transmission ID help

    So i am putting my motor back in with a new clutch and I check the fit of the pilot bearing in the crank thats good but on the trans input shaft it is very loose about a tenth of an inch too big the id that is, I also planned on changing the throwout bearing retainer which I bought from summit...
  11. C

    Installing rockers on screw in studs

    I installed a Ford motorsport E303 cam and new heads with screw in studs where do I postion the rockers on the studs from the getgo?
  12. C

    Smog pump delete

    I am putting my car back together and wanted to remove the smog pump because I do not need to take my car for emissions testing other than a shorter belt or smog pump delete idler what else do I need to do just rip all the smog stuff out or will that screw up the cpu?
  13. C

    MAF conversion vs custom chip on an 88 5.0

    I have read about alot of problems/issues with the conversion on 1986-88 5.0s why would'nt a new cpu or chip tailored to my new specs work just as good?
Top Bottom
Back
Forums
Menu