Search results

  1. montyd

    E85 Injector And Pump Size?

    I'm doing a 351w swap in my 93 lx. Going to run and on system with a 70mm turbo. I think I need 80lb injectors to run e85 but I'm not positive. Also wondering what size fuel pump to run and what mass air to run or if everyone goes to speed density at this point. Shooting for 600rwhp. Thanks for...
  2. montyd

    351w Swap With 70mm Turbo

    I'm swapping a 351 w roller motor into my 93 lx. I'm going to run the on3 kit with there 70mm for now. I'm wanting to swap to e85 at the same time. I know I need roughly an 80lb injector but I'm unsure as to fuel pump size. And also what mass air to go with? What's everyone running? Or are guys...
  3. montyd

    electrical issues

    I got my car out for the first time in about a year. Its a 93 lx. And I had a charging issue so I pulled the alternator and it tested bad so I replaced it. Got the new one on and it still had a low reading on the gauge. O I turned the headlights on to see if the gauge would drop and it pegged so...
  4. montyd

    f303 cam vs Anderson n41 cam?

    In wondering about switching to the Anderson n41 cam. I currently have a f303 in my car. The car is a 93 lx, edelbrock performer heads and intake thats mildly ported. Stock bottom end, 24lb injectors, long tubes and undecided midpipe. I called Anderson and told them my setup and they suggested...
  5. montyd

    Expired **feeler** 1993 Lx 5.0 Reef Blue, Black Interior, Hatch

    feeling out the market a little bit. im kicking around selling my 93 lx, its reef blue, factory black interior, factory 5 speed and 5.0 car. motor has edelbroc heads and intake, f cam, rebuilt bottom end, mac long tubes x and flows, stainless tips. welded in sub frame connectors, upr chromoly k...
  6. montyd

    Forced Induction Installed Supercharger, Now The Car Is Slower?

    so i installed a powerdyne( i know its not the best but it was cheap) on my 93 lx and the car lost ALOT of power. it has edelbroc performer heads. ported and polished edlebroc performer intake, 70 mm edelbroc throttle body, f cam(retarded 4 degrees on the timing chain) basically stock bottom end...
  7. montyd

    Anyone Know Where To Find Fender Liners?

    hey guys, i have done searches both on stangnet and everywhere else online and cant seem to turn up any fender liners or splash shields for the front fenders of my 93 lx, anyone know where i can get a new set or a nice used set?
  8. montyd

    Wont Idle

    i have been driving my car for the last 4 straight days with no problems. (have put 260 miles on it since sunday morning). tonight i decided to make a mount for my mass air meter since it was all taped to the inner fender untill i decided what intake to run. i put the mass air back in exactly...
  9. montyd

    Drive Train Vibrations

    hey guys, i have had a vibration in my drive train for a while and have been trying to figure out what is wrong, it the worst over 60 mph, i can start to feel it around 45-50. im going on the hot rod power tour in two weeks and would like to have it fixed for the event. i changed my drive shaft...
  10. montyd

    will this cause a miss?

    hey guys drove the car for the first time this year yesterday. and i have a miss. the rotor hat rust on the end of it and the contacts on the cap look like they were welded with out the gas turned on lol lots of little holes and the metal crumbles off. would that cause my miss? there are...
  11. montyd

    blue box under the dash?

    ok guys got the wiring firgured out and drove the car. needs a little work but thas not important. there is a blue box under the dash that is beeping. it sounds like the door dinger is sick. but it does it when your going down the road and when the door is shut. it beeps in 5 beep bursts for...
  12. montyd

    cold air intake

    hey guys, i recently installed the scot rod engine compartment panels and hid all my wiring and painted the engine comparment. now its perfectly smooth, no holes anywhere, and im looking for a clean cold air intake set-up anyone have any suggestions? thought about buying one of the sve set ups...
  13. montyd

    electrical help! key on no power

    hey guys. i just got done running all the wires under my dash and i hooked up my selenoid and i have no power to it. if i touch the battery wire to the oposite side of the selenoid everything comes to life if the key is on. if i shut the key off it all goes off. put the positive battery cable...
  14. montyd

    351w gt40 lower intake

    i have a gt40 lower intake. it looks like it was bolted on but never run. there is no carbon in the runners all thread holes are perfect. it still has 19lb injectors and fuel rails on it and they will go with it. this is the lower only. it is for a 351 windsor it came off a cobra r or...
  15. montyd

    93 lx reef blue factory black interior 5 speed 5500

    93 mustang lx reef blue with factory black interior and 5 speed. the paint was new last fall it has a 4 inch cowl hood and a non factory sun roof. teh motor has 5k on it. it has factory forged internals, edelbroc performer aluminum heads, edelbroc performer 2 intake thats been ported and...
  16. montyd

    94 gt help! runs for a min and then dies after intake swap

    i have a 94 gt. it was bone stock with the exception of a cold air intake and an x pipe and bassani mufflers. today i swapped the intake out for a 95 cobra upper and lower intake. i also installed 24lb injectors a pro flow mass air off my other 93 mustang that is calibrated for the 24lb...
  17. montyd

    edelbrock performer and performer 2 wet nitrous plate

    have an edelbrock nitrous plate. will fit the performer and the performer 2 for a wet kit goes between the upper and the lower intake make me an offer 574 276 0423
  18. montyd

    93 cobra crate motor more info

    ok so we hooked the scanner up and with the motor off key on it pulled code 85, wit the key on and the motor running it pulled code 41 and 91, starting to think the 02 sensor is bad and causing the lean condition on the left bank any thoughts?
  19. montyd

    new ford 93 cobra crate motor help!!!!

    ok guy im totally stumper. i have a 91 gt vert that i bought with no motor. it has an aod with a 2800 stall converter and shift kit,and 4:10 gears we got a 93 cobra long block right from the local ford dealer and it has no power. it wont even do a decent burn out. hears what it does, at 4k...
  20. montyd

    how big of a cowl hood do i need?

    i have a one inch spacer for my cobra intake. wondering how big of a cowl hood i need to clear it.
Top Bottom
Back
Forums
Menu