Search results

  1. NOSNotch

    I have no vent controls

    I would say vacuum line too but Im pretty sure if the vacuum is disconnected you only get air out of the defrost vents. If you're gettin air just out of the main vents i would say maybe the door in the heater box is stuck or maybe somethings wrong with the heater controls themselves, like maybe...
  2. NOSNotch

    WTF Sn95 5 lug swap and wheels wont bolt up..

    Just got done puttin in my tubular k, a arms, drag springs and doin the sn95 front brake swap and when i went to bolt my wheel on it smacked the caliper bracket. I've got ProStar skinnys but i didnt think there'd be any kinda fitment problem. Now i gotta decide whether to yank the 95 stuff and...
  3. NOSNotch

    What is it?

    ttt, anyone???
  4. NOSNotch

    What is it?

    I yanked my dash tonite for the 2nd time so I could swap out my pedals and re route the dash harness. makin room for the harness to go thru the cruise control hole in the firewall i removed this plastic box. It has two plug spots in it and was on the left behind the kickpanel mounted to a...
  5. NOSNotch

    5spd or C4????

    I'm about ready to put the motor in my project coupe and I'm not sure which trans i'm gonna go with. For a mostly street car do you guys prefer a T-5/Tremec or an automatic like a C4? If not your opinion what do you run in your car? Thanks for any opinions guys Kevin
  6. NOSNotch

    Too much injector for this setup?

    I've got a freshly built 306 with ported twisted wedge heads, a street heat intake, 70mm tb and a custom grind cam w/about .560 lift. I have a full Aeromotive fuel system for it w/braided line, rails and an A1000 pump. I have a set of 30lb injectors for it right now but i've been hearing thats...
  7. NOSNotch

    fuel pressure reg install help

    The regulator is not that bad to do. I'm assumin you have a mostly stock setup so I'll try to tell ya all i can. Pull the intake elbow, disconnect the throttle cable, unplug the tps, iac and egr valve, remove the two coolant hoses from the egr spacer, carefully remove all the vacuum lines...
  8. NOSNotch

    stock crossmember with C4?

    I'm doin a T5 to C4 swap soon and the last thing I have to worry about is the crossmember. Will a stock V8 crossmember work or do I need to get an adjustable one? Thanks guys Kevin
  9. NOSNotch

    how much fuel pressure for this setup?

    A buddy of mine has a lx hatch he just got, we put an adjustable regulator on it tonite and I wanna try to get the most out of it. He's got an X cam, Dart heads, Performer RPM II intake, 70mm tb, 24lb injectors and 77mm mass air. What would be the best spot for the fuel pressure? Thanks in...
  10. NOSNotch

    Underbody rust repair???

    Whats up guys, my coupe is about to go to the paintshop and I've got something else I want to try getting fixed while the car is down. The underside has some surface rust on it. The floors are solid but some spots back towards the rear and around the spare tire well have some surface on em, no...
  11. NOSNotch

    4 banger Notch to 5.0 conversion

    Well goin carb makes it a bit easier. I dont think the 4cyl 5spd will hold up too long and i'm not even positive it will work. Like you said you will have to swap rears and you will need the rear brake line or get one bent up so the exhaust isn't close to it. You'll need a crossmember, tailpipe...
  12. NOSNotch

    Tach problems in 99??

    A buddy of mine has a 99 GT. He bought it with an Autometer tach already installed. When the car is idling the needle is all over the place, it stays close to true but it "shivers" and is not accurate at all revving or cruisin. So he bought the Tach Ready box from Dallas Mustang. i installed it...
  13. NOSNotch

    Optima batt: Yellow or Red??

    I'm planning on ordering my battery box tomorrow and i was gonna get an Optima battery as well but which is better and/or what are the differences between the yellow and red top batteries? Thanks in advance for any replies Kevin
  14. NOSNotch

    Reattaching molding on door

    The front of the molding on the door of my 87 is starting to come loose. It's hanging out enough that when i open the door it gets caught on the fender so i want to reattach it somehow but I'd rather not pull the whole molding off. Any ideas on how to reattach it? I'm tryin to avoid just putting...
  15. NOSNotch

    Anyone using Eibach Drag Launch kit?

    I just got a set of Eibach Drag Springs with the airbag for Xmas. I'm prob gonna try to install this weekend. Before I put em in i just wanted some opinons on what those using them thought of them? Also how does your car sit with the springs installed? Some are telling me they're car sits like a...
  16. NOSNotch

    99 up GT seats.

    Heres a couple of the 00 seats in my coupe.....
  17. NOSNotch

    Electric or mechanical oil press?

    I know this topic has been up numerous times but i just want to know what you all think? Electric or mechanical oil pressure gauge or would you say no difference? Thanks in advance to any replies Kevin
  18. NOSNotch

    99 up GT seats.

    The holes for the seats are the same, they will bolt right in, as for wiring up the power, if i remember right there's a 4 wire plug on the 99 seat, just cut that off then the two green are power and the black is ground and the remaining is for the seat belt light which u leave unhooked. Een if...
  19. NOSNotch

    Belt suggestions?

    Whats up guys, on my 306 I'm runnin just alt and waterpump and trying to keep it as simple as possible. I have the march setup with the adjustable rod that hooks from water pump bolt to the top alt bolt. Is it possible to just run the belt to the passenger side keeping it under the water pump...
  20. NOSNotch

    PA Performance 3G Alternator

    I went with a '95 Alt instead of going thru PA but I did call them up for the stator connector as well as a megafuse, they got the stuff out right away and were polite when i ordered, i had gotten 2 stators (one for a friend) and they forgot one, when I called back they gave me absolutely no...
Top Bottom
Back
Forums
Menu