Search results

  1. 2

    Injector Filter Removal Help

    any have info on where to gets these new injector filter screens ,i have tried all the local parts stores no luck,,i ripped a few of them while i was cleaning some injectors for an efi460,,noticed they were really clean for the highmileage it had, the fuel filter gets rid of all micro dirt...
  2. 2

    Can someone tell me how to get my heat to work, detailed pics inside

    for example of units go to www.stepvanparts.com look in the heaters section,auxliary heaters,,sorry this pc can't send pics,,,,just get all new 5/8 hoses/elbow fittings,,,everything has to be new and secure,,,i know i have seen these in some vans at the local junk yard but i don't know if the...
  3. 2

    Can someone tell me how to get my heat to work, detailed pics inside

    forgot to mention these systems come with their own blower fan in case you are wondering,,,the stock cores plug up very easy,,good luck
  4. 2

    Can someone tell me how to get my heat to work, detailed pics inside

    hey i installed a remote heator core,got it from a step van,,you can get them also from rear compartment conversion vans,,,the core i got is pretty thick around four inches,,ran the hoses through the floor board,direct 110 house switch ,i like them those switches never melt,,,direct 12vcurrent...
  5. 2

    e7heads FIT ON AN E6 BLOCK WITH FLAT TOPS?

    thanks ,,forgot to mention stock e6 cam for now
  6. 2

    Heater problem????

    oops didn't read your post right,,since you already replace the core,you probably need to bleed the air out of it a bit,,i had to rev it up a little and disconnected one hose for a couple of seconds to bleed the air
  7. 2

    Heater problem????

    i installed a remote heator core assembly ,,got it from a step van,,,just rerouted the hoses,they enter through the floorboard,,the hoses make nice hand warmers,,what car comes with that factory option:),,,,,have to drive with the window half down sometimes,gets f-hot,,,have it located in front...
  8. 2

    e7heads FIT ON AN E6 BLOCK WITH FLAT TOPS?

    will i have to flycut the stock 1986 flat top pistons since they have no reliefs in them,,i want to put some e7 heads,,,will the compression be too high?? the block is roller cammed,,,thanks
View older results
Top Bottom
Back
Forums
Menu