Search results

  1. Philstang

    Help with buzzing relay !!! Electrical gurus come in!!!

    This is on my truck but please help if you can... I recently replaced the clutch fan with an electric fan. My problem is when my fan has been running and then turns off (controlled by temp sensor), the relays begin buzzing like crazy, when the fan comes back on, it goes away... Please help!!!
  2. Philstang

    different Q about subframes c/arms...

    I know that you need to load the suspension before welding on subframe connectors. I have some new upper/lower control arms that I eventually plan on adding to my project car. Will it be okay to weld in the subframe while the stock suspension is in there still or would it be best to put the new...
  3. Philstang

    DCControllers Question... Yount

    Well I looked at the price of these and it wasn't bad at all for the controller. I will get the fan used off of eBay or a junk yard. Would the DC35 or the DC60 be best for a Taurus fan on my fox? What if I come across the Mark8 fan? DC35 or DC60? Thanks :SNSign:
  4. Philstang

    Installed Ford Racing axleback

    switch to a chambered muffler...
  5. Philstang

    Cold Air Intake QUESTION

    C&L inlet pipe has a spot for it...
  6. Philstang

    Manifold Cover

    don't do it, that is the upper runners for the intake manifold, it is not just for looks, lol
  7. Philstang

    Non-permanent way to make the air bag black

    why would you want to switch it back to tan if you are set on it being black ?
  8. Philstang

    help identify my alternator...

    anyone know how to test this bugga for it's amperage or to positively identify it, any special marking that would identify it...
  9. Philstang

    Electric fan ?

    at the very least run a relay with 8 ga. wire being sent through it, with 18 ga. wire as the 85,86 prong activation wires...
  10. Philstang

    help identify my alternator...

    thanks for the input Hissin, anyone else have an idea?
  11. Philstang

    Taillight Problems

    <---- had one side stolen before....
  12. Philstang

    help identify my alternator...

    This is the alternator that was on the coupe when I got it... I was trying to determine if this is a 2g, 3g or other alternator and if the wiring has been properly upgraded... (I attached a 4ga. wire from the positive battery post to the + on the alternator with a 125amp fusible link on the...
  13. Philstang

    electriconics guys- come in, delay question for E-fan...

    electronics guys- come in, delay question for E-fan... To start with, I know about the DC controller... Alright, I am going to be setting up my own budget E-fan controller using 3 relays in series, 2 temp probes and a 2spd fan. The first relay will be closed normally but switched open by...
  14. Philstang

    Intakes

    So a pricey Volant would be worth your money??? Why not run a new, non-corrogated tube from the TB to the stock airbox, and then enlarge the hole that feeds air into the bottom of the airbox?
  15. Philstang

    floor board broken

    On my old hatch I had this problem, the best way to fix it is take it to a place that does collision repair. Should be just a quick weld job and then respray of the necessary coatings, shouldn't be too expensive either.
  16. Philstang

    Steeda Full length subframe connectors

    what's the best way to achieve this with ordinary jackstands, without relieving the suspension... ? Thanks
  17. Philstang

    please advise me whether or not to buy this 89 notch with a blower for a DD

    I wouldn't want it as a daily but definitely a great weekend strip car, still sounds like a super deal for all the goodies it has. Don't worry about the dirty interior, it should clean up well.
  18. Philstang

    Cobalt SS

    nah, a real Cobalt SS from Chevrolet will have a supercharger...
  19. Philstang

    V6 x-pipe

    y-pipe is a 2 into 1 design, like the factory...